Get matched with top drain pipe installers in Hermosa, SD

You can buy a sealant spray for a leaking copper pipe, but it’s not a permanent solution and isn’t usually a good idea. For the best adhesion, you should drain the pipe, let it dry completely, apply the spray, and wait for it to dry before turning the water back on. Even with proper technique, a sealant spray is a temporary fix, so you should only use this technique in the interim to prevent water damage if you’re waiting for a more permanent fix.

No. You should never directly drain a water softener into a sewer cleanout. This practice is illegal in many areas because it could allow raw sewage to get into your drinking water and make you seriously ill. Many places have codes requiring a specific seal, pipe, and a large air gap between a water softener and a sewage cleanout. Check out Florida's Plumbing Building Code as an example of what these restrictions might look like.

For a long time, copper was our only plumbing material option. Thankfully, that is no longer the case. Copper pipes have been used since the 1940s and became most popular around 1963. It wasn’t until the 1990s that PVC pipes became popular and began to replace copper pipes. Therefore, a house built before the 1990s without recent updates will likely contain more copper pipes.

You might be able to find your pipe leak by doing a visual inspection around your appliances and under your sink. Don’t forget to check your water heater too. If you find moisture or puddles of water, then you know you’re on the right track—you may need a repair or water heater replacement.

Knowing how to find a water leak can be tricky, but you can try the paper towel method. Lay paper towels on the floor and see where the moisture lands. You can also wrap toilet paper around pipes to locate a small leak.