Top-rated masons.

Get matched with top masons in Newell, SD

Enter your zip and get matched with up to 5 pros

Need a pro for your masonry work project in Newell, SD?

Select your specific project to find the pro for you.

Find Masons in Newell

Avatar for 413 Services
413 Services
5.0(
13
)

Serving Newell, SD and surrounding areas

Approved

In business since 2021

Free estimates

Emergency services offered

"Project- Dig trench and install root barrier for tree roots that are invading my property from my neighbors tree. Also trimmed up the ash tree in the back. Excellent job on both, completed both projects in good time and did a great job was happy with the results. Will definitely call again."
Motion Unlimited
Motion Unlimited
Running out of daylight
Equipment
BC 1800

+20

Response time2 days
19 neighbors recently requested a quote
Recommended by76%of homeowners
Avatar for Dowden Creative Construction, LLC
Dowden Creative Construction, LLC
4.9(
16
)

Serving Newell, SD and surrounding areas

In business since 2019

Free estimates

Offers commercial services

"Crew started on time, work was completed on time. Quality of work was there but Had an increase in cost due to mis-figure of how much fill was needed."
Stamped Patio
Stamped Patio
Stamped Patio
Exposed Aggregate
Exposed Aggregate

+15

Response time2 days
Response rate86%
Recommended by100%of homeowners
Showing 1-10 of 34
Masonry questions, answered by experts

The best tool for drilling into brick or mortar is a rotary hammer drill which is a large hammer drill with low rotation speed and high torque. Regular drills with a hammer function are also excellent tools for drilling into brick when the diameter of the hole is 1/2 inch or less. It might be possible to drill into brick with a standard drill if you’re only drilling a very small hole, but note that masonry work will put a lot of wear on a standard drill, and the tool may not be strong enough to get through brick.

Spalling brick is not uncommon, but it does indicate a serious issue. It can be caused by water damage, an intense freeze-thaw cycle, or something else. Painted bricks can be susceptible to spalling, as the paint doesn’t allow the porous material of the brick to breathe, which can trap moisture. Spalling should always be addressed immediately before more serious structural damage occurs.

Limewash can be removed from brick, but the method of removal will depend on how long the limewash has been on the brick. If the limewash has fully dried—which happens after about five days—you’ll need to use a diluted muriatic acid mixture to remove it. If there are multiple coats of limewash, you may need to apply the acid mixture several times to fully remove it from the brick.

If you’re attempting to mix and pour your own mortar, expect to pay between $5 to $10 for an 80-pound bag of mix. The cost to repair mortar, however, can range from $300 to $500 for a 20-square-foot wall. The larger the area and the more extensive the repair, the higher the cost.

Use fire bricks for a brick pizza oven. These bricks are typically used for fireplaces and chimneys as they can withstand high temperatures from heat sources. If you attempt to use any other kind of bricks, it’s likely that this material will crack from such high heat exposure in the best case—and potentially explode and cause serious harm in the worst case.

The Newell, SD homeowners’ guide to masonry services

From average costs to expert advice, get all the answers you need to get your job done.