Get matched with top drain pipe installers in Hot Springs, SD

The most common places for water leaks in a home are the fixtures we use most often: the kitchen and bathroom sinks, the showerhead, and the toilet. These components all contain moving parts and O-rings that prevent water from flowing through when the fixtures are shut off, and these can wear down over time and lead to minor drips or significant leaks. You can sometimes employ a DIY solution to replace aerators or faucet O-rings that could be causing the leak, but it’s usually best to call in a professional for a permanent fix.

A water hammer refers to the banging or knocking sound you hear in your water pipes after you turn off your faucet or when your washing machine or dishwater fills. This happens when highly pressurized water suddenly stops moving in your pipes due to a valve closing or your well pump shutting down quickly. Try adjusting the pressure setting on your water pressure tank—it should be below 50 psi (pounds per square inch). Or have a plumber install a water hammer arrestor.

Anything you drop down your sink runs the risk of damaging and clogging your pipes. Hair, bits of food, and other debris can catch on the item and build up over time, causing a clog. Even if it’s not valuable, it’s definitely worth trying to retrieve the item, or at the very least, asking a pro for specific advice.

No, putting new plumber’s tape over old plumber’s tape is not recommended. The old tape connection may not be completely adhered and could cause a leak. 

Instead, remove the old tape completely, clean off the pipe threads with a clean rag and wire brush if needed, then apply new plumber’s tape to make your connection.