Top-rated sink installation pros.

Get matched with top sink installation pros in Eureka, SD

Enter your zip and get matched with up to 5 pros

Need a pro for your sink installation project in Eureka, SD?

Select your specific project to find the pro for you.

Find Sink installation pros in Eureka

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)

Serving Eureka, SD and surrounding areas

In business since 1971

Credit card accepted

"AHS is ok. They cover repairs of most everything under the roof of your house. The companies that contract with them are not always the best. You call AHS with the issue, they send a fax to the repair company and give you the contact info. If they don't contact you within 24 hours, you call them. Sometimes they answer, sometimes they don't. When they arrive (usually three days or so later), they service the item. if it has issues within the 90 days, you call AHS again, they are sent out with no charge. If the serviceman decides the unit is unrepairable, AHS will allow you to choose a replacement from their listing (usually not as good as what you have) they will install and remove your old item, or give you wholesale amount to buy and install your own. Prices vary on what you want covered and what you want the copay to be, plus where you live. For me it is 49.99 per month with a 75.00 time of service order. You can have more than one item serviced at the same time under the same fee. If you have a SEAR product the repair guys are great. Not that wild about the other ones they send out. But it is a big savings compared to calling someone on your own. The cost of service is only the 75.00 copay."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Sink Installation questions, answered by experts

Deteriorated seals, O-rings, or gaskets are common culprits behind a leaky sink after you’ve turned off the water—especially if your sink is older than 15 years. Inspect each of these mechanisms in your sink for signs of corrosion or looseness, then replace the worn-out part to fix it. Older sinks may be worth replacing if several of the parts are worn-out.

If your sink is on an exterior wall that isn’t insulated, or if pipes travel through a cabinet against an exterior wall that prevents heated air from circulating around the pipes, the pipes can freeze, causing them to burst. The best way to avoid leaking sinks is to insulate the pipes and open cabinets in the short term to warm the water line up and prevent freezing.

Never pour used motor oil down the drain. Doing so can have serious environmental consequences, including contaminating groundwater, endangering animals, and killing vegetation. It can also clog your pipes, causing backups in your plumbing or the wastewater treatment plant. In most places, pouring motor oil down the drain is illegal, whether you do it in your home or a storm drain.

No, you don’t need to use plumber’s putty to install a sink drain. Other options are available, such as silicone putty or silicone caulk. Plumber’s putty is the traditional method and it’s easier to work with and easier to remove. It doesn’t need to dry before using. Silicone putty should dry before you use the drain.

Yes, there are different size sink drains, but a 1 ½-inch-diameter drain is the most common modern drain size. However, some sink drains are 2 inches or 3 inches in diameter. A bathroom sink drain is 1 ¼ inches in diameter, and kitchen sink drainpipes are 1 ½ inches in diameter.

The Eureka, SD homeowners’ guide to sink installation services

From average costs to expert advice, get all the answers you need to get your job done.