Get matched with top masons in Carpenter, SD

No, you don’t need to soak the brick before cutting it by hand. In fact, cutting a wet brick can make it harder to see your score lines and may cause the chisel to slip. Soaking is sometimes used with power tools to reduce dust, but for hand-cutting, it’s best to work with dry bricks for better control and visibility.

No, using a power sander on brick is not recommended because the force of the sander can destroy brick's fragile outer layer. Even using sandpaper on brick is discouraged because of the damage its abrasiveness can cause.

A traditional German schmear uses mortar, making it unsuitable for adherence to painted surfaces. Professionals recommend removing any existing paint before applying mortar. However, you can rough up the painted surface and clean it to test if the mortar will stick. Remember that the underlying paint's texture and color may affect the schmear's final appearance—so starting with a bare brick wall will ensure the ideal finish.

Brick spalling—which refers to the crumbly, flaky, or pitted appearance that can develop over time—is caused by a few different conditions. These include:

• Climates with constant freeze-thaw cycles

• Use of non-breathable sealants

• High-pressure water cleaning

• Improper installation

While you can’t do anything about the weather, you can preserve your bricks by cleaning them with soapy water and a good old-fashioned scrubbing. Pressure washers may be satisfying to use, but they can eventually wear away the surface of your bricks. If you don’t have advanced-level DIY skills in masonry, you can hire a reputable masonry contractor in your area for your project.