Get matched with top pool table assembly pros in Westmont, PA

No, according to the CDC, animals do not usually pose health risks to swimmers, even if one dies. If a pool is maintained well, chlorine should kill any germs left by an animal within minutes. That said, homeowners should remove the animal as soon as possible and clean and disinfect the pool afterward.

If a pool turns green after adding salt, there’s a good chance the salt is the problem. Certain brands of salt have high levels of iron that cause pool water to take on a green hue. Test your pool water to determine if this is the issue. The green color will usually filter out. Brush the sides of the pool to knock the iron off.

This is just one reason a pool can turn green that is specific to adding salt. Many other reasons a pool can turn green include algae growth, low chlorine levels, a faulty filter, etc.

The total time to install an inground pool typically ranges from 8 weeks to 4 months. This timeline can be influenced by several factors, including permitting, site preparation, and the construction process itself.

Key phases and their typical durations include:

• Permits: Obtaining necessary permits can take anywhere from two to six weeks.

• Excavation and Site Preparation: This phase takes about a week but can be extended by problematic soil, unexpected ground conditions, or the need to move underground utility lines.

• Construction: The actual build, including plumbing and electrical work, often takes one to two months. The pool material is a major factor here; a concrete pool needs about 30 days to cure, while installing a fiberglass or vinyl liner is much faster.

External factors can also cause significant delays:

• Contractor Availability: Spring and summer are busy seasons, and high demand can lead to long waitlists, potentially adding months to your start date. It is often recommended to start planning and getting estimates up to a year in advance.

• Other Delays: Weather, material shortages, complex designs, and other unforeseen challenges can extend the project timeline.

Water only runs through a pool heater when not in use if the heater doesn’t have a bypass system. A bypass system stops the flow of water through the heater when not in use. If you don’t have one, then yes, water will still run through the pool heater even when not in use. Not having a bypass system may increase the effects of wear and tear on your pool heater or disrupt the water’s chemical balance.