Top-rated deck maintenance specialists.

Get matched with top deck maintenance specialists in Lemont, PA

Enter your zip and get matched with up to 5 pros

Need a pro for your deck maintenance project in Lemont, PA?

Select your specific project to find the pro for you.

Find Deck maintenance specialists in Lemont

Avatar for Harmon's Handyman
Harmon's Handyman
4.9(
7
)
Deck, Fence, Patio or Porch - Clean and Seal

Serving Lemont, PA and surrounding areas

Approved

Free estimates

"Very impressed with the quick response and efficient job!! My spouting and down pipes were completely blocked. Jordan evaluated the problems and explained each step that needed to be done. Excellent work!!"
Soffit/fascia repair
Soffit/fascia repair
Pressure washing
Pressure washing
 exterior door trim

+3

13 neighbors recently requested a quote
Avatar for Wolf Brothers Painting, LLC
Wolf Brothers Painting, LLC
4.6(
23
)
Deck, Fence, Patio or Porch - Clean and SealDeck, Fence, Patio or Porch - Clean and Seal - For Business

Serving Lemont, PA and surrounding areas

In business since 2014

Free estimates

Small jobs welcome

"Matt painted my living room and kitchen of my new house, and it looks beautiful. I am absolutely, completely satisfied with 95% of it. There are a couple walls, however, with some uneven spots and dripping that looks like that work was rushed at the very end."
Residential interior
Residential interior
Residential interior
Photo 6
Residential interior

+3

Response time2 days
Recommended by85%of homeowners
Showing 1-10 of 46
Deck Maintenance questions, answered by experts

Most building codes require that spindles or balusters on deck and stair railings be spaced no more than four inches apart. This safety standard, often called the '4-inch sphere rule,' is designed to prevent small children or pets from slipping through the railing. A good way to visualize this is that a 4-inch sphere should not be able to pass between two spindles. For the same safety reason, the space between the bottom rail and the deck floor should also be no more than four inches. As a general guideline, professionals often install three balusters per foot of railing. However, since specific requirements can vary by location, it is crucial to check your local building codes to ensure compliance before starting your project.

When building a deck, #2 grade lumber is a go-to for several reasons. It’s strong, budget-friendly, and works well for most framing and decking needs. But upgrading to #1 or Appearance Grade can give your deck that extra visual edge if you're after a cleaner, more polished look for high-visibility spots.

The best time to paint your deck is when temperatures are neither too cold (below 60 degrees) nor too hot (above 85 degrees). Always paint your deck when there’s no risk of rain. For fast-drying paint like acrylic or latex, ensure your deck can dry for at least four hours. Oil-based paints take longer to dry and may require 48 hours to completely cure.

Yes, deck pier blocks can be used as an alternative to traditional deck footings, especially for smaller or low-to-the-ground decks. Unlike poured concrete and buried post footings, deck blocks do not require digging or pouring. However, their use is dependent on local building codes. Some areas, particularly those prone to high winds, earthquakes, or hurricanes, may not permit the use of deck pier blocks. It is essential to consult your local building codes before choosing them for your deck project.

Footings for ground-level decks need to be at least 12 inches deep, and some areas require them to be even deeper. A standard range for deck footings is anywhere from 12 to 48 inches. The minimum footing depth is determined by an area’s frost line and soil conditions. If you’re unsure how deep to install deck footings, check local building codes to find the minimum footing depth in your area. 

The Lemont, PA homeowners’ guide to deck maintenance services

From average costs to expert advice, get all the answers you need to get your job done.