Best epoxy flooring pros near Lakeview, OR

To prep a floor for painting, start by sweeping and cleaning any loose debris that could puncture the protective material. Take out as much furniture as possible. Then lay plastic, canvas, rosin paper, or masonite sheets across the room, securing them at the edges with masking tape. Plan your painting so that you minimize the chances you’ll step in and track any splatters.

Yes, you can seal old concrete, but proper preparation is essential. Before sealing, ensure the concrete is clean, dry, and free of any old sealant. To check if resealing is necessary, place a few drops of water on the surface; if they are absorbed in less than five minutes, it's time to reseal. If you are using the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are applying a different type of sealer, the existing one must be removed. Additionally, repair or fill any cracks to create a smooth base before you begin sealing.

To properly maintain an epoxy garage floor, regularly sweep up dirt and debris using a broom and dustpan or a vacuum cleaner. Mop with warm water and scrub away stains using a mild cleaning solution that's safe for the epoxy product you have installed. Don't use any soap-based or chemical cleaners, as these can cause the epoxy surface to deteriorate more rapidly.

Yes, you can seal an old concrete floor as long as you remove stains and repair damage before sealing. Remove everything from the garage and clear the floor throughout with a concrete cleaner and power washing. Fill in cracks larger than 1/8 of an inch wide and remove all grease and rust stains before sealing. Make sure your concrete is fully dried before applying sealer.