Top-rated asphalt driveway pros.

Get matched with top asphalt driveway pros in Wilburton, OK

Enter your zip and get matched with up to 5 pros

Need a pro for your asphalt driveway service project in Wilburton, OK?

Select your specific project to find the pro for you.

Find Asphalt driveway pros in Wilburton

Avatar for Owens Excavation & Dirtwork Corp
Owens Excavation & Dirtwork Corp
5.0(
3
)
Gravel or Loose Fill Paving - Install, Spread or Scrape

Serving Wilburton, OK and surrounding areas

Approved

In business since 2021

Offers commercial services

Customers say: Quick response

"Great company to work with.... I had several projects for the past couple years including: 2 ponds dug - no leaks & holding solid, built roads, had coverts installed, clearing of land and trenching work for electrical. I would highly recommend, they've done a wonderful job every single time. Extremely professional to make sure it's done right and that you're happy with services provided. I would work with them again on any project needing large requirement in the future."
Response time1 day
5 neighbors recently requested a quote
Recommended by100%of homeowners
PERMALIFT FOUNDATION REPAIR LLC
4.3(
61
)
Concrete Driveways & Floors - Install- For BusinessConcrete Driveways - Install

Serving Wilburton, OK and surrounding areas

In business since 2002

Credit card accepted

"I recently bought a house and a few issues were pointed out by inspections. These guys were referred to me by friends and after getting a few bids, I had them fix my problems. They werent the cheapest, but they fixed my issues and that was all that really mattered to me.
"
Recommended by93%of homeowners
Avatar for J Construction
J Construction
4.9(
14
)
Asphalt Paving - Install

Serving Wilburton, OK and surrounding areas

In business since 2000

Credit card accepted

Offers commercial services

"We couldn't afford to entirely asphalt our 1/2 mile driveway but Levi proposed a combination of asphalt and chip and seal that fit our budget. Our driveway is smoother than it has been in years and we don't have to worry about putting our vehicles in 4 wheel drive after a rain. Levi explained everything beforehand and kept us updated daily throughout the process. Zero complaints."
Response time1 day
Response rate95%
Recommended by100%of homeowners
...
Showing 1-10 of 64
Asphalt Driveways questions, answered by experts

While paving a driveway is possible to do as a DIY project, we don’t recommend it. Hiring a driveway professional to pave it will ensure that your driveway looks neat and clean and lasts for years to come, and it will also prevent a weak driveway and, potentially, damage to your foundation. Paving a driveway requires heavy machinery, and while you can rent the equipment needed, operating it close to your garage slab or around your home’s foundation can crack it and lead to structural issues. 

Building a road on a slope requires careful planning and will normally require a drainage system underneath to prevent flooding and damage to the road over time. Your professional may lengthen your road to create switchbacks if the slope directly to your home is too steep, as there are regulations for maximum road slope. The drainage system will help prevent runoff from the higher side of the slope from damaging the asphalt or concrete. Keep in mind that building a road on a slope isn’t a good DIY project, as a lot can go wrong.

Asphalt, which is stone mixed with tar, is the most common material for outdoor basketball courts because it’s so sturdy and versatile. However, you don't have to use it: another option is polymeric rubber, which has shock pads that can prevent injury. This option is a little more expensive, ranging between $16 and $25 per square foot.

Materials used for indoor basketball courts, such as hardwoods, aren’t really an option outdoors.

New asphalt goes through two stages: drying and curing. Drying typically takes 24 to 72 hours, after which the surface is solid enough for light use like walking or careful driving. While you may be able to park on it after 72 hours, the surface is still soft and should be treated gently. Full curing is a much longer process, taking anywhere from 30 days to a full year for the asphalt to reach maximum strength. During this extended curing period, the asphalt is susceptible to damage from heavy vehicles, sharp objects, and high temperatures. Factors like weather, the specific asphalt mix, and application thickness all influence drying and curing times. For the most accurate timeline and to ensure the longevity of your new asphalt, it is always best to consult with your installation contractor for their specific recommendations.

At a depth of two inches, a ton of asphalt covers around 80 to 100 square feet. However, the thicker the asphalt, the less surface area it will cover. That’s why measuring correctly is essential when estimating asphalt needs and costs to ensure you get enough material to cover your entire driveway, patio, or other asphalt surface.

The Wilburton, OK homeowners’ guide to asphalt driveway services

From average costs to expert advice, get all the answers you need to get your job done.