Top-rated sandblasting pros.

Get matched with top sandblasting pros in Norman, OK

Enter your zip and get matched with up to 5 pros

Need a pro for your sandblasting service project in Norman, OK?

Select your specific project to find the pro for you.

TRUSTED BY NORMAN, OK HOMEOWNERS

  • Average homeowner rating star icon4.7
    Average homeowner rating
  • Verified reviews icon289
    Verified sandblasting services reviews

Find Sandblasting pros in Norman

Avatar for Bryce Case Construction
Bryce Case Construction
5.0(
2
)
Exterior Surfaces - SandblastingExterior Surfaces - Sandblasting - For Business

Serving Norman, OK and surrounding areas

Approved

In business since 2015

Free estimates

Emergency services offered

"I called him with a need for a gate to be replaced on a property I was about to move into. He was on his way out of town, but did the job immediately after returning. He did an excellent job. The gate was not what I envisioned, but was much better. I would definitely use him again."
Response time2 hrs
Recommended by100%of homeowners
Showing 1-10 of 47
Sandblasting Services questions, answered by experts

Soda-blasting systems are slightly more expensive than sandblasting systems. To soda blast, you’ll need to spend a few hundred dollars for a blast hose and nozzle, a compressed air supply, a blast generator, a moisture decontamination system, and sodium bicarbonate media, a recurring cost because the powder is not reusable. To start with sandblasting, you will need to spend upwards of $30 for a blast pot, a blast gun, an air compressor, and sandblasting media, many of which are recyclable—further reducing the cost. The total cost for either will depend on the size of the system.

Sandblasting removes old paint, rust, and grime efficiently, providing a clean surface for refinishing.

Costs depend on paint type, surface condition, labor, and required prep work for repainting.

Your pro will most likely bill you at an hourly rate of $50 to $80 per hour to sandblast a door due to its small size. This type of job won't take long, so if you have other surfaces that need cleaning, schedule those tasks at the same time to get your money's worth from your pro's visit.

The best way to sand a deck is by cleaning it, sanding the boards and stairs with 60- or 80-grit sandpaper, and sanding the railings and posts with 80-grit sandpaper. You should sand in the direction of the wood grain to avoid damaging the timber. When sanding your deck, use medium pressure and aim for an even sand. Pressing too hard with a sander can damage decks, as most are softwoods.

The Norman, OK homeowners’ guide to sandblasting services

From average costs to expert advice, get all the answers you need to get your job done.