Get matched with top stucco pros in Fletcher, OK

The decision to repair or replace stucco depends on the extent of the damage. For minor issues like small cracks, holes, dirt, stains, or discoloration, a repair is typically sufficient and more cost-effective. These issues can often be resolved with a simple repair, a deep clean, and possibly a new coat of paint. However, for more significant problems such as large cracks, peeling, mold, algae, or structural water damage, a replacement might be necessary. In these cases, it is best to call a professional stucco contractor for an inspection. An expert can assess the severity of the damage, determine if there are deeper issues, and advise whether a repair is adequate or if replacing a section or an entire wall is the more cost-effective, long-term solution.

Solid, unpainted stucco shouldn’t suffer damage from dots of glue used for this task. If the stucco is dirty, you may notice slight marks when you heat and peel the glue away, but these aren’t permanent.

However, not all stucco walls are solid stucco. Some are “faux” stucco with a foam backing. This kind of stucco veneer is more susceptible to damage, including damage from hot glue. We don’t suggest attaching anything to these kinds of stucco walls, so make sure you check the stucco type before starting this project.

Homeowners insurance may cover the cost of siding repair or replacement, but coverage depends on the cause of the damage. Most policies will cover damage from a covered event, such as a storm, wind, hail, fire, natural disaster, or other impact damage. Your policy might pay for the full or partial cost of the repair or replacement. However, damage resulting from age, general wear and tear, or neglect is typically not covered, and you should expect to pay for those repairs out of pocket. It is best to review your specific homeowners insurance policy for full details on what is covered, how to file a claim, and what documentation is required.

To repair damaged exterior stucco, you’ll first remove all loose and crumbling material from the damaged area. You then need to thoroughly clean the area and dampen it to ensure proper bonding. After that, you’ll apply a bonding agent to the repair area, then apply new stucco in layers, allowing for curing time between each layer. The final coat should be textured to match the surrounding stucco pattern as closely as possible. Once fully cured, the repaired area can be painted to match the rest of the wall if needed.