Get matched with top insulation pros in Cleora, OK

Structural insulated panels and rigid foam boards have the highest R-value of any insulation that contractors commonly use, with R-values reaching up to around 8.0. These types of insulation are best in extremely cold climates, but they’re generally preferred for new construction, as they can be challenging to retrofit. Blown-in and loose fill insulation provide the next best insulative value, provided the installation is done properly. It’s important to choose an insulation type that meets your needs based on climate, as maximizing R-value may not always be financially worthwhile if you live in a moderate climate.

You can purchase bags of cellulose and loose-fill fiberglass blown-in insulation from the same local home improvement store where you rent your blower. If you want to use rock wool insulation, you may need to special order it.

On average, insulating an attic costs about $2,500, with a typical range of $1,500 to $3,500. The final price often depends on the attic's size, with costs generally falling between $1 to $3 per square foot. For example, insulating a 1,800-square-foot attic would likely cost between $1,800 and $5,400.

If the project involves removing old insulation, this can add an average of $900 to the total cost, bringing a full removal and reinsulation project to around $3,000.

Several factors influence the overall cost:

• Insulation Type: Prices per square foot vary significantly by material.

• Reflective: $0.50–$1.50

• Blown-in: $1–$4

• Batt: $2–$4

• Loose-fill: $2–$5

• Spray foam: $2–$5

• Structural insulated panels (SIPs): $4–$7

• Project Complexity: Factors like sealing air leaks, poor attic accessibility, and required inspections can add to the cost.

• Removal Issues: The discovery of mold, asbestos, or pests during the removal of old insulation can substantially increase the price.

Yes, PEX pipes should be insulated in certain situations. While insulation is not always necessary for pipes running through insulated interior or external walls, it is recommended for any pipes located in uninsulated rooms, unheated areas, or outside, especially in regions with cold winters. The primary reason is to prevent freezing. Although PEX is more resistant to cracking from freezing than other materials, repeated freezing and thawing can weaken the pipes over time, increasing the risk of a burst.