Get matched with top bathtub restoration pros in Wintersville, OH

No. You should let the caulk completely dry before you expose it to moisture. It’s safest to wait at least a full day before showering where you’ve recently caulked. Showering before caulk is fully dry can lead to a poor seal, meaning water can seep into cracks and cause damage and mold growth. 

It’s substantially less expensive to reglaze a tub than to replace it. The average cost of reglazing a bathtub is between $400 and $700, but that range may be higher based on where you live and the type of tub you have. Meanwhile, if you want to replace the bathtub, you’re looking at $2,000 to $9,400, with the average close to $5,700.

While tubs are fairly sturdy, you may notice cracks or holes. This kind of damage can happen from someone accidentally dropping something heavy into the tub. You might also see damage if you drop something heavy into the tub over and over again (like your extra large bottle of body wash). While you might only notice a small dent at first, this can later turn into a crack or a hole.

Also, certain cleaners that are harmful to your tub can cause damage. And if you have a fiberglass tub, you might see cracks if it was not installed properly with the right support.

Before you begin caulking a shower, you’ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to get rid of the mold, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter’s tape—one above the joint where you’re caulking and another below it.