Top-rated lighting pros.

Best lighting pros near Crooksville, OH

Enter your zip and get matched with up to 5 pros

Need a pro for your lighting service project in Crooksville, OH?

Select your specific project to find the pro for you.

Top-Rated Lighting pros in Crooksville - Updated Nov 2026

Artium Electric
5.0(
223
)
Outdoor Lighting - Plan and Install

Serving Crooksville, OH and surrounding areas

In business since 2018

Free estimates

"Robert at Artium replaced a ceiling light for us. The old light was at least 50 years old and had been installed incorrectly. Robert explained what he had to do, took the old light down, repaired the insulation on a couple of the old wires and installed the light correctly. He is very friendly and courteous. The work was done when promised and his rate is very reasonable, probably on the low end. We will use him on our next electrical projects."
Response time1 day
Response rate94%
Recommended by95%of homeowners
Avatar for Homemade Design
Homemade Design
3.7(
322
)
Designer - Interior Lighting Plan

Serving Crooksville, OH and surrounding areas

In business since 2006

Credit card accepted

"It is a waste of money. The great majority of people are not going to find any value out of the service. If you need design consultation, you need a full service consultation. If you already have knowledge and experience, and you just need to get a few ideas, then you don't need to pay for that. You can just get a magazine or a book since you already have the knowledge of basic designs in your head or a little bit of experience. To have someone call you and give you information over the phone, you are not getting the personal service that you need. You may as well take the money $49 and apply it to something else like getting someone else to come out and give you the service that you need. Because, you are not getting much, you are not getting anything at all. They are going to have you do the work. After talking to them and I was talking to other home designers, I found out that that was a waste of time and waste of money. I gave them a C because they didn't fail at what they do but they don't offer any value for what they do. There's not much value to it. The cost was fair. They didn't do a terrible job and the cost isn't terrible, it was only $49. It just has a very low value. For responsiveness I gave them a B because they will answer your phone and answer your emails."
Pennsylvania Master Bathroom
Boston Small Condo Kitchen
California Client Saves with HMD Designer Discounts
Recommended by54%of homeowners
All Valley Electric, LTD
4.7(
4
)
Designer - Interior Lighting PlanOutdoor Lighting - Plan and InstallOutdoor Lighting - Repair

Serving Crooksville, OH and surrounding areas

In business since 2007

Free estimates

Emergency services offered

"We needed a microwave replaced and All Valley Electric said they could get it done. While some wanted up to $200 , All Valley gave us a price of $75. The blizzard caused a delay but they called a few days later and within an hour he was removing the old microwave and installing the new. He was very clear on what had to be done and had the new micro in place within minutes. He even set the clock. I hope to use them again."
Recommended by100%of homeowners
Showing 1-10 of 13
Lighting FAQs, answered by experts

While wet-rated and damp-rated lighting is designed to handle contact with moisture, there’s a difference between the two. Wet-rated lighting is safety-rated to be placed in areas with direct exposure to water, including your shower. Fixtures classed as wet-rated are made with waterproof seals to protect the filament and other electrical components from water and moisture. 

Damp-rated fixtures can be used in places with some moisture contact, but not direct exposure. They don’t have the same waterproof seals used in wet-rated fixtures. Damp-rated lighting can be used on your bathroom ceiling or along a wall outside of your shower.

If half of a string of Christmas lights is out, it is likely because of a single burned-out, loose, or broken bulb within that section. Long strands of lights often contain more than one circuit, so when one bulb fails, it can cause the entire circuit (or half the strand) to go dark. To fix this, inspect the unlit section and test each bulb to ensure it is tight and functioning properly. Replacing the faulty bulb or repairing a damaged shunt will typically solve the problem.

The average cost to install outdoor or landscape lighting is around $4,000, with most projects ranging from $2,000 to $6,000. The total cost can vary widely depending on several factors, including the number of fixtures, design complexity, and the type and quality of the lights used, such as wall sconces, pathway lights, or lamp posts. Other factors that influence the price are the square footage of the area being lit, the amount of electrical work needed, any required excavation or trenching, and local permitting costs. For specific types, you might pay around $100 for pathway or string lighting and up to $700 for lamp post lighting.

The cost to repair a short circuit depends on the type of repair. A faulty outlet or simple loose wire can be a simple fix that might only cost a handful of dollars. For example, if you need to rewire a house, you’ll spend around $2 to $4 per square foot, but replacing an entire electrical panel costs anywhere from $500 to $2,100.  

The majority of potential burglars are amateurs looking to make a quick buck after breaking and entering. By installing motion-sensor lights, alarm systems, and security cameras, throughout the home, there’s a good chance you will deter crime on your property.

The Crooksville, OH homeowners’ guide to lighting services

From average costs to expert advice, get all the answers you need to get your job done.