Get matched with top roofers in Orangeburg, NY

Roof raking can damage shingles if improperly done. Be sure to use a rake that’s designed specifically for removing snow from a roof, and don’t use excessive pressure. Light, consistent pressure to pull down the bulk of the snow is all that’s needed—if you clear right down to the shingles, you’re probably using too much force and risking roof damage.

Properly installed chimney flashing can last anywhere from 15 to 50 years. However, flashing generally only needs to be replaced when it is damaged, corroded, or no longer creates a watertight seal. Several factors influence its longevity, including the material type, quality of installation, and local climate. For example, copper flashing tends to last longer than galvanized steel. Large storms and extreme weather can also damage flashing, potentially requiring earlier replacement. To ensure its longevity, it is recommended to have your chimney and roof inspected annually. A professional can assess the flashing's condition and recommend any necessary repairs.

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

Building an A-frame roof falls under the category of constructing a steep roof. While its structure is relatively simple, its height and requirements for more materials than a shallow roof design can increase its cost significantly. Expect prices for building an A-frame roof to hover around average to slightly above average.