Get matched with top sump pump installation pros in Oakfield, NY

A sump pump's lifespan is typically 7 to 10 years, though the general range can be anywhere from 5 to 15 years. The specific type of pump is a major factor: pedestal sump pumps last an average of 20 to 25 years, whereas submersible sump pumps last between 5 and 15 years. While pedestal pumps are less expensive to service, they are also louder and more prone to clogging.

Several other factors influence longevity, including the pump's quality, usage frequency, and maintenance schedule. A high-quality pump that is well-maintained in a dry climate may last for two decades, while a lower-quality, poorly maintained pump in an area with a high water table or frequent flooding may fail in six years or less.

Regular maintenance, including annual inspections and tuneups from a professional, can significantly extend the pump's life. It is time to consider a replacement if your sump pump runs constantly, cycles frequently, shows visible rust or corrosion, or trips a circuit breaker. As a preventative measure, many homeowners replace their pumps every eight years. It's also worth noting that a manufacturer's warranty can indicate expected lifespan, and some home insurance policies may not cover water damage from a pump that is past its recommended replacement date.

When a backflow valve fails, wastewater will flow back into your system, contaminating your drinking water. You’ll immediately notice backflow valve failure from a rotten smell and brown water coming from faucets. Get in contact with a septic pro or a plumber immediately if you suspect this has happened to you.

If you notice any new sump pump noises, such as persistent clanging or gurgling, then you likely have a sump pump problem on your hands. Foul odors coming from the pump can also indicate problems. Additionally, if your unit turns on but doesn't pump water, you might have to address electrical problems. In any of these cases, it's a good idea to hire a professional to address the issue.

First, you can try unplugging the two sump pump cords, one for the motor and one for the float switch, then plugging them back in to reset the sump pump. You can also reset the sump pump by turning it off and back on at the breaker. Many sump pumps have a reset button, which you can press and hold for a few seconds to reset the device.