Top-rated above ground pool installation pros.

Get matched with top above ground pool installation pros in Frewsburg, NY

Enter your zip and get matched with up to 5 pros

Need a pro for your above ground pool installation project in Frewsburg, NY?

Select your specific project to find the pro for you.

Find Above ground pool installation pros in Frewsburg

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)
Above Ground Swimming Pool or Accessories - Repair or Service

Serving Frewsburg, NY and surrounding areas

In business since 1971

Credit card accepted

"One oven doesn't work at all ( my choice, see above), the "working" oven was never calibrated properly so using it is hit or miss. It's time to call American Home Shield to see about replacing the entire unit. I'm waiting to finish other home projects before calling them. I don't know if I'll request Greenway again."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Install Above Ground Pools questions, answered by experts

No, stock tank pools do not get too hot, even when they are set up in a sunny location. Many stock pools are made with galvanized steel and are designed not to get too hot to touch. When your pool is full of water, it is less likely to get hot. The water might be warmer than it would be in an above-ground pool, but it will not be uncomfortable.

If you have kids and want to be extra cautious about the temperature of the stock tank, you may want to set up an umbrella for shade over the pool area.

Yes, pool pumps use a significant amount of electricity, making them one of the biggest energy consumers in a home. A pool pump can use up to three times as much electricity as a refrigerator. Typically, a residential pool pump consumes about 1 kilowatt-hour (kWh) for every hour it runs. Because pumps often need to run for about eight hours a day to properly filter the water, this can add up to an annual consumption of 3,000 to 5,000 kWh, which can cost between $480 and $800 per year based on average electricity rates.

The amount of electricity your pump uses depends on its size, energy efficiency, and daily run time. To lower your energy consumption, you can choose an energy-efficient or variable-speed pump, ensure it is correctly sized for your pool, and run it only for the minimum time required to keep the water clean.

Yes, swimming in a pool with high calcium hardness is considered safe as long as you have sufficient chlorine and pH levels to keep bacteria growth under control. The main issue with high calcium hardness is that it damages your pool through rust and corrosion. However, if your water is hard enough to corrode your pool, you might want to consider finding methods to make it safe for drinking at home.

Technically, you can fill in a pool yourself—with the caveat that filling in a pool requires the ability to drain the pool properly and move a substantial amount of dirt, which aren’t beginner DIY skills. If you want to fill in a pool, you’re better off hiring a local pool removal professional.

You don’t need to drain the whole pool to patch a pool liner, but be prepared to dive in with your swimsuit and goggles to patch a leak below the water level. By draining the pool, you can actually expose the liner to more harsh conditions, like wind and sunlight, that cause the tears to worsen. It’s best to use the ink test and waterproof patches or tape to identify the leak and patch it up.

The Frewsburg, NY homeowners’ guide to above ground pool installation services

From average costs to expert advice, get all the answers you need to get your job done.