Top-rated furniture refinishers.

Get matched with top furniture refinishers in Stanley, NM

Enter your zip and get matched with up to 5 pros

Need a pro for your furniture refinishing project in Stanley, NM?

Select your specific project to find the pro for you.

Find Furniture refinishers in Stanley

Enhancement Wood Flooring
New to Angi
Furniture - RefinishFurniture - RepairFurniture - Upholster

Serving Stanley, NM and surrounding areas

Approved

I have started a wood flooring co in Edgewood NM. I have 25 yrs experience in the industry. I am licensed and insured, do both residential and commercial. \n\nI offer many services Install Sand and Refinish. I can do do board replacements, and lace in repairs.\n\nIn addition I can do almost any handy man task, framing, sheetrock, tape texturing, install doors, windows.

5 neighbors recently requested a quote
Avatar for Complete Mobile Detail
Complete Mobile Detail
4.7(
24
)
Upholstery and Furniture - Clean

Serving Stanley, NM and surrounding areas

In business since 2003

Free estimates

Emergency services offered

"We were very pleased with the results. Adam and his two co-workers (sorry, I did not get their names) were here on time, even a little early after calling first to see if that was acceptable. It was a cold day, but they didn't complain and went right to work. It took them about 2.5 hours to complete.  The engine looks like it came off the show room floor. We were very happy and would use them again. They were all very friendly and our car looks brand new.
"
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+11

Recommended by91%of homeowners
Showing 1-10 of 23
Furniture Refinishing questions, answered by experts

You should consider the time needed to clean and prepare your bedroom set for transit. A few days before moving, vacuum, dust, and clean your furniture with a mild cleaning solution. Depending on the movers and the services you pick, you might need to pre-pack the mattress and box spring in boxes designed for beds and disassemble some furniture by removing doors and hardware. Finally, don’t forget to take plenty of pictures documenting the pre-move condition in case you need to file a claim.

Avoid using wood filler for structural repairs or areas with extensive damage. Wood filler is designed for cosmetic fixes like filling small holes, cracks, or surface imperfections, and it doesn't provide the strength needed for load-bearing repairs or large gaps. You also shouldn’t use wood filler in areas exposed to heavy moisture or extreme outdoor conditions unless it’s a product specifically rated for such environments. Wood replacement or a strong epoxy resin is a better solution for severe rot or structural damage.

Minor water damage on wood tables can be reversed fairly easily. You can remove stains and light surface damage with a sandblock, then repaint and re-varnish the wood surface. For swollen and rotten wood, you can cut away the damaged parts and use a wood filler as long as the affected area isn’t too much.

Wood putty is made with a plastic adhesive, while wood filler is made from sawdust or wood products. The primary difference is their application: wood filler is used to repair the interior portions of wood, whereas wood putty is best for exterior sections because it contains chemicals that could damage the inside of the wood. If a crack or hole goes into the middle of the lumber, wood filler is the correct product for the job.

Pros cover many fixes, from upholstery renewals to joint reinforcement.

The Stanley, NM homeowners’ guide to furniture refinishing services

From average costs to expert advice, get all the answers you need to get your job done.