Get matched with top concrete finishing pros in Sapello, NM

The biggest downside to resurfacing concrete is its lifespan. Concrete resurfacing lasts for five to ten years, on average, while a new concrete slab would last for 20 to 30. The cost of concrete resurfacing is much lower, but you get more value from full replacement. Resurfacing also doesn’t address any underlying issues with your slab, so you may need additional repairs, like mudjacking.

Yes, adding a patio or other concrete feature can increase your property taxes, particularly if it's considered a permanent improvement. The general rule is that if the project requires a permit, your property taxes will likely go up.

Permanent structures like a poured concrete patio are considered capital improvements that require a permit, which will trigger a reassessment of your property's value. Other concrete projects that typically increase taxes include:

• Pool decks

• Walkways

• Driveways

• Steps

• Foundations

In contrast, 'temporary' installations, such as a paver or flagstone patio, may not require a permit and are less likely to affect your property taxes.

Permit costs for a concrete patio can range from $75 to $200. While the tax increase varies based on your location and the project's size, it is often a minimal amount. Always contact your local building department before starting a project to confirm permit requirements and any potential impact on your taxes.

Yes, you can change the color of concrete countertops multiple times. If you use paint rather than a stain, you can go from dark to light, but if you are only using a stain, you can go from light to dark.

Concrete resurfacing and concrete overlay are terms often used interchangeably to describe the process of applying a new, thin layer of pre-blended concrete over an existing slab. This process enhances the durability and appearance of the concrete, giving it a fresh look without the high cost of a full replacement. The new layer is typically between 1/4-inch and 1-inch thick, significantly less than the 4 inches required for a new slab, and can be stamped, colored, or textured for a custom finish.

While the terms are often considered the same, their meaning can sometimes vary by contractor. Some may use "overlay" to describe a thicker application that adds structural integrity, while "resurfacing" might refer to a thinner layer intended for cosmetic upgrades. Other common names for this process include concrete restoration, concrete refinishing, and concrete rejuvenation.