Best toilet pros near Ranchos De Taos, NM

Even though they’re modern-looking, easier to clean, can be hung at any height, and help save space compared to traditional toilets, wall-hung toilets have some downsides. They’re more expensive than standard toilets, sometimes by a few hundred dollars. They’re also difficult to install and may require major plumbing work to reroute the drain if the previous toilet was a floor-mount model.

This tight fit can make repairs more difficult. You’ll also have to consider where you can hang them and weight limit restrictions, so they may not be the best fit for every home.

Hiring an emergency plumber is expensive because of the urgency and inconvenience, but there are a few things you can do to help keep costs down:

• Minimize water damage by shutting off your water main 

• Clean up pooling water immediately to reduce damage and mold growth

• Avoid using fixtures if you have a clog or septic system backup

• Verify that your plumber is licensed before hiring

• Call a few plumbers for estimates if you can afford a short delay in getting service

While a leak may seem small, even a gentle trickle of consistent moisture can lead to mold problems in your bathroom. Make sure you know how to check for mold if your toilet has been leaking for a while. Pooling water by your toilet also poses a risk for someone slipping on the slick floor of your bathroom. Finally, a leak of any size can lead to water waste that increases your water bill.

You generally cannot replace a 10-inch rough-in toilet with a 12-inch model without making significant plumbing updates. A 12-inch rough-in toilet will not fit a 10-inch rough-in space because the floor drain is in the wrong position. To accommodate the larger toilet, you would need to move the drainpipe, which could cost between $0.75 and $30 per linear foot, plus labor. In most cases, it is more cost-effective and simpler to purchase a new 10-inch rough-in toilet. However, it is possible to install a 10-inch rough-in toilet in a 12-inch space by using a longer connector.