"I called several plumbers. Most wanted $80 just to give an estemate. Glenns Plumbing LLC and 1 other company gave me a free estemate. Glenns was almost half the price and after much conversation it was more than apparent that he knew what he was talking about and was a professional plan. In the end he installed the water softening unit and replaced a good portion of the hot water heater piping..., he did an exceptional job. I am extremely happy with his service and craftsmanship."
"The service went very well. I called and asked if a plumber could come and change our expansion tank off of our hot water heater and was told that the plumber would be there between 1 and 3. About 15 minutes before 1, the plumber called and asked if he could come by. The service at the house went well and he used buckets and towels to make sure he didn't spill water everywhere. The water that did drip on our garage floor was cleaned up before he left. They accept credit cards and are very professional, I'd use them again! "
We take pride in our company's reliability, great communication, integrity, and quality work. We are experts in our trade and will do our best to keep you as educated as we can on your particular task or project. We look forward to earning your business!\n
Been in business since 1990. No project too big or too small. Customer satisfaction is our motto, financing is available. Senior discount for Angies list customers.
Oasis Plumbing has been in business since 2003. You will find that they are fully insured and meet the New Mexico state's licensing requirements. They specialize in Plumbing and HVAC work. Jason, the owner has many years of experience before he started his own company.
ALL SERVICE PLUMBING & GAS LLC is the leader in providing our customers with the highest quality service in an honest, efficient, and professional way. Our pledge is to create successful relationships with our customers, employees and community by building trust, treating every project with the utmost integrity and exceeding expectations. We look forward to working with you!\n
Tankless water heaters heat water as it passes through the unit instead of storing heated water in the tank. Their ability to produce hot water on an as-needed basis makes them more efficient. However, they are generally more expensive than traditional units. Is a tankless water heater worth it? Most homeowners will save money with a tankless unit in the long run by using less energy.
While not all homes require a hot water heater expansion tank, they are necessary in most newer homes and are often mandated by local building codes. Codes typically require an expansion tank if your plumbing system is a 'closed-loop' system, which often includes a backflow preventer or pressure regulator on the main water line. Some municipalities have specific requirements. Installing an expansion tank on a closed system is crucial, as it prevents excess pressure that can damage your water heater and other appliances, potentially shortening their lifespan. However, tankless water heaters do not require an expansion tank.
Most standard residential water heaters, which are typically around 40 gallons and use 240 volts and between 3,500 and 5,500 watts, require a 30-amp, two-pole circuit breaker. For smaller, point-of-use water heaters using 120 volts and between 1,500 and 3,000 watts, a 30-amp breaker is also often adequate. However, some models may have different needs; units that use more watts than average may require a 40-amp breaker, while smaller units might only need a 20-amp breaker. Newer, tankless, or more energy-efficient models can also require a higher amperage. Having the correct breaker size is crucial for safe and efficient operation, so it's best to consult a licensed electrician to determine the specific needs of your water heater.
The chemicals in a water softener can wear down the anode rod in the heater and shorten its life span. However, for most people, the benefits of the softener outweigh this potential drawback.
Have a plumber inspect the anode rod annually for damage, as replacing the anode rod is far less expensive than replacing the entire water heater.
The average cost to install a new water heater is approximately $1,300, with a typical price range between $880 and $1,800. The final cost depends on several factors, including the type and size of the unit, its location and accessibility, and the amount of labor required. For example, installing a unit in a tight space like a crawl space can increase labor costs. The type of water heater significantly impacts the price: while a conventional gas heater might cost less than $1,000, tankless models can cost around $2,600 to install (and up to $3,500), and solar heaters can cost upwards of $3,700. Other factors that can affect the total price include the fuel type, vent system requirements, permits, and whether any additional plumbing work or repairs from previous water heater damage are needed.
The Lake Arthur, NM homeowners’ guide to water heater services
From average costs to expert advice, get all the answers you need to get your job done.
A water heater flush costs $160 on average but can vary based on the unit size, type, labor, location, and more. Keep reading to learn how much you could pay.
Worried your water heater might freeze this winter? Learn to spot the warning signs and how to safely thaw your tank or tankless system out if necessary.
Hybrid water heaters will have you weighing high initial costs versus long-term savings. Is it the right option for you? Explore the pros and cons of hybrid water heaters.
The average lifespan of water heaters is 6 to 15 years for conventional models and up to 20 for tankless ones, but it can be less if they are not properly maintained.
