Get matched with top well and pump technicians in Estancia, NM

The average three to four-bedroom home typically uses a well pump rated for 8 to 12 gallons per minute (GPM). To find the most accurate size for your specific needs, a common rule of thumb is to count the number of water fixtures and appliances in your home and aim for that number in GPM. This calculation allows for about one gallon of water per minute per fixture. Because estimating the correct size can be challenging, it's best to have a professional technician make the final determination. A professional can ensure your pump provides sufficient water for your home, especially during peak usage hours.

If you have a well-related issue, such as your well water stopping, you should hire a local water well contractor or a well and pump repair professional. These specialists handle all aspects of wells, including the pump, tank, and other outdoor water pumping equipment. They can inspect your system, recommend and perform repairs, and even coordinate a water quality test if needed. While plumbers are experts in indoor plumbing, they may not have the specialized experience with residential wells that a dedicated well contractor does.

The cost to replace a well-pump motor will depend on the size, but this repair is often as costly as installing a new pump. Generally, a well-pump replacement will cost between $950 and $2,650, with an average of $1,800. Other factors like pump type and pipework will impact your final cost.

Most well pump pressure switches have a factory setting of 30 to 50 PSI. There’s some flexibility with this if you’d like a lower or higher water pressure, but remember that it should sit 2 to 3 PSI above your well tank’s general pressure setting.

The inside of your pressure switch cover will usually indicate minimum and maximum settings—going below and above the numbers might damage your well pump.