Get matched with top epoxy flooring pros in Scottsbluff, NE

The best way to resurface a concrete porch is to clean and prep the surface, pour a layer of concrete on top, allow it to cure, then seal it. A concrete overlay provides a durable layer and enhances your porch's look. You can even choose a stamped overlay to make it look like stone or brick. To ensure structural integrity, repair concrete cracks before applying the new concrete. If the existing concrete is in significant disrepair, consider removing and replacing the concrete instead of an overlay.

The best time to seal your concrete driveway is sometime in the spring and fall when the temperature is above 55 degrees Fahrenheit. Keep an eye on the weather, and be sure to pick a day without rain on the forecast for at least 24 hours. Lastly, be sure you can leave the space free of foot and car traffic for the full drying time.

Yes, you can seal old or existing concrete, but proper preparation is crucial. The concrete surface must be clean, dry, and free of any incompatible old sealant. To check if an old sealer is present, drip a few drops of water onto the surface; if the water is absorbed in under five minutes, it's ready to be resealed. If you plan to use the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are using a different type of sealer, the old one must be completely removed. Before applying the new sealer, thoroughly clean the concrete and repair or fill any cracks to ensure a smooth, well-prepared surface.

Resurfacing a garage floor takes about eight hours on average, with another couple hours over three days to do the epoxy. Epoxy goes on in three coats, with each coat taking 24 hours to dry and cure. You’ll need to keep foot and vehicle traffic off of your garage floor for around 4 days in total when replacing your garage floor, so be sure to plan ahead before you start. This is a great time to organize your garage since you’ll need to move everything out to apply the epoxy.