Get matched with top drywall pros in North Platte, NE

The best way to make long, straight cuts is to use a utility knife and a T-square to score the sheet, snap along the score, and then finish the cut by cutting through the paper on the opposite side with the utility knife. If you’re making small cuts, curved cuts, or cutouts for electrical boxes or light fixtures, you can use a manual jab saw to keep costs down, but an electric spiral saw or oscillating multi-tool will get the cleanest, fastest cuts possible.

Here’s another instance of where the answer is you could, but that doesn’t mean you should. Yes, part of the issue is getting the drywall to stay in place on the tiles, and it’s understandable that screws will crack the tiles and cause them to crumble. That’s why it’s a much better idea to screw drywall into studs, not your porcelain or ceramic tile. But aside from issues with attaching the drywall, it’s also about ensuring a smooth application without trapping moisture inside.

It is more difficult to drywall a ceiling than it is to drywall a wall, but not so hard that DIYers can’t tackle it. One of the main issues with hanging drywall on your ceiling is getting it into place. Drywall isn’t light so, if you are hanging full drywall panels, you will need at least two (it’s better with more) people to hold the panel while you drill it into the ceiling as a single piece can weigh between 40 and 60 pounds and will need to be held in place for up to 10 minutes.

Yes, it is possible to DIY install drywall, but it is a deceptively complicated process that can be quite frustrating if you don’t have experience. Prepare to cut and screw drywall, leave the proper gap distance for any seams, never leave the end of a piece of drywall hanging off of a stud, and cut out around electrical boxes and switches. Plus, getting the drywall to look good is challenging, especially when taping and spackling. That’s why it’s usually a better idea to hire a professional drywall installer to ensure high-quality results.