Get matched with top bathtub restoration pros in Norfolk, NE

There are a few signs, both obvious and not so obvious, that it's time to refinish your bathtub. While some of these signs aren't an urgent problem, others could lead to significant damage if left untreated. Signs you should look out for include:

• Rust stains, which signal the tub's enamel or surface sealer is deteriorating 

• Small chips, which can grow into larger chunks and can lead to rusting

• Discoloration, which doesn't lead to a more significant problem but can be unsightly 

• Dirty surfaces, which means that the tub glaze is breaking down and allowing dirt to seep below the coating

For a standard-sized bathtub with minor damage, it takes approximately 3 to 5 hours to refinish. It might take a bit longer if your bathtub refinishing contractor needs to fill in significant cracks or gouges. This is the same if you have a specialty tub, like an oversized bathtub—you can expect your pro to take a bit on the longer side.

Bathtub refinishing refers to the entire process of resurfacing a bathtub. Reglazing is one step in the bathtub refinishing process. To refinish a bathtub, a refinishing professional will clean the tub, protect the surrounding areas, remove the existing glaze, sand and prepare the surface, apply the new glaze coating, caulk the tub, and replace the fixtures.

Most homeowners need to wait at least two days, sometimes three, to use their bathtub following the reglazing process. That’s the normal length of time it takes for epoxy resin to cure. There are quick-dry epoxy kits available that cure in 12 hours, though. To ensure that the epoxy dries properly, try to ventilate the bathroom as well as you can.