Get matched with top cabinet makers in Lyons, NE

Using a shim or another type of self-leveling feet on the bottom edge of your cabinet bases will help to level them out if you’re installing them on a less-than-level surface. To make this process easier, you can add your shims before attaching the bases to your cabinets while they’re still light and easy to move around.

Most built-in bookshelves are custom-made to fit the available space and meet a homeowner's needs. This level of customization allows you to design the exact look and functionality you desire. However, you can buy cheaper, prefabricated bookshelves to slot into your desired space. However, prefabricated designs might not slot in as snuggly or need to be adjusted to fit.

Most cabinetry made for a garage will have special coatings and finishes built to withstand extreme heat and cold, moisture, pest damage, rusting, and dry rot. However, many homeowners have put their old kitchen cabinets in the garage, added a couple of fresh coats of paint, and use them for a while without too much wear and tear.

The 1/3 rule is a design guideline used by interior designers and cabinet installers to select appropriately sized pulls for cabinets and drawers. The rule suggests that for a balanced and cohesive look, a cabinet pull should be approximately one-third the height of the cabinet door or one-third the width of the drawer face. This guideline helps create a symmetrical appearance because the human eye tends to follow the length of the pull across the cabinet face.

While the 1/3 rule is a helpful starting point, it is not the only option. If a measurement falls between available pull sizes, it's generally best to size up. For an ultra-contemporary aesthetic, you can also opt for full-width pulls that span the entire drawer.