Get matched with top marble restoration pros in Hershey, NE

You should always seal cut countertops to prevent damage and to keep them looking their best. The right way to seal countertops depends on the type of material. For laminate and wood, apply epoxy or other specialty sealers by pouring it onto the countertop and letting it flow across the whole surface to the edges, guiding it with a paint stick or putty knife. You will need to move quickly so that it does not dry or harden before you are done. For stone countertops, use a sealant specially manufactured for your type of stone and apply it according to manufacturer directions. 

A water-based, low- or no-VOC sealer is typically a good choice for marble countertops. Choose a sealant that is certified safe for contact with food when applying to kitchen countertops. For high-traffic areas, look for formulas that have heat-resistant and acid-resistant features. While there are economical and convenient spray-on sealers, they don’t coat the surface as effectively as the ones you apply with a pad or brush. 

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.

Yes, you can remove an undermount sink from granite countertops. However, it’s safest to hire a granite pro to take on this job. Your pro might have to make cuts and grind the granite to remove the sink. Plus, if you’re replacing your sink with a larger one, you’ll need your pro to enlarge the existing sink cutout in your granite.