Top-rated epoxy flooring pros.

Best epoxy flooring pros near Curtis, NE

Enter your zip and get matched with up to 5 pros

Need a pro for your epoxy flooring service project in Curtis, NE?

Select your specific project to find the pro for you.

Top-Rated Epoxy flooring pros in Curtis - Updated Nov 2026

Avatar for alcconcrete
alcconcrete
4.8(
5
)
Concrete Finishing, Overlays & Coloring - Apply

Serving Curtis, NE and surrounding areas

In business since 2022

Free estimates

"We are extremely satisfied with the work done. They did the work in a timely and efficient time frame. They were pleasant to work with and left everything as neat and clean as could be expected from this job."
Concrete - Pouring & Repair Project
Concrete - Pouring & Repair Project
Driveways - Concrete Project
Concrete - Pouring & Repair Project
Driveways - Concrete Project

+5

Recommended by100%of homeowners
Burns Construction
0.0(
2
)
Concrete Finishing, Overlays & Coloring - ApplyConcrete Floor Coating-ApplyConcrete Floor Coating-Apply - For Business

Serving Curtis, NE and surrounding areas

In business since 2000

Free estimates

Burns Construction, is a full service general contracting firm operating in the greater SW NE area for many years. We pride ourselves in our attention to detail and our unsurpassed customer service. The quality of our work speaks for itself and we look forward to working with you on your next project.

Recommended by100%of homeowners
Epoxy Flooring FAQs, answered by experts

Yes, you can seal old or existing concrete, but proper preparation is crucial. The concrete surface must be clean, dry, and free of any incompatible old sealant. To check if an old sealer is present, drip a few drops of water onto the surface; if the water is absorbed in under five minutes, it's ready to be resealed. If you plan to use the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are using a different type of sealer, the old one must be completely removed. Before applying the new sealer, thoroughly clean the concrete and repair or fill any cracks to ensure a smooth, well-prepared surface.

Epoxy and polyurethane sealers can last five to 10 years, while acrylic sealers last two to three years or more depending on the use, wear of the surface, and type of sealer you choose. Areas that see heavy traffic or extreme ice and snow may require more frequent sealing. Test your concrete every two years to gauge how it responds to absorbing water or if it fully repels it for longer than 20 seconds.

The best way to resurface a concrete porch is to clean and prep the surface, pour a layer of concrete on top, allow it to cure, then seal it. A concrete overlay provides a durable layer and enhances your porch's look. You can even choose a stamped overlay to make it look like stone or brick. To ensure structural integrity, repair concrete cracks before applying the new concrete. If the existing concrete is in significant disrepair, consider removing and replacing the concrete instead of an overlay.

When you’re painting a garage floor, it’s best to use a combination of rollers and brushes. You’ll want to start with a brush, making a border around the edges where the floor meets the wall. From there you can use a roller, though some people also like to do the entire first coat with a brush because it’s easier to work the paint into the textured concrete.

No. You cannot use asphalt products on concrete driveways. To seal a concrete driveway, use acrylic, epoxy, polyurethane, silane, siloxane, and silicate sealers or deep penetration sealers made specifically for concrete. Meanwhile, asphalt sealers contain refined coal tar (asphalt emulsion), water, sand, clay, polymers, and additives and are incompatible with concrete’s surface texture and higher density.

The Curtis, NE homeowners’ guide to epoxy flooring services

From average costs to expert advice, get all the answers you need to get your job done.