Get matched with top toilet pros in Chadron, NE

The most common toilet repair is dealing with clogs, followed closely by replacing a worn-out flapper. While clogs can happen anytime in any toilet, they most commonly occur with older toilets that have smaller diameter clearances and often empty into smaller diameter sewer connections. Because toilet flappers only last a few years, they are next in line for the most common toilet failures.

After flushing the toilet, you should have about half a tank full of water. While the exact amount of water you’ll have will vary, you want to make sure you have enough to cover the bottom of the bowl and enough to sit above the P-trap drain. While low water in your toilet bowl can indicate a problem, too much water can also be cause for concern.

Basement toilets don’t always need a pump. However, it is the most common setup because plumbing systems use gravity to move waste away from the home. Basement toilets often sit below the home’s main sewage system, and installing a sewage ejector pump pushes the wastewater and sewage up to the main sewer line. Alternatively, you can use an upflush or macerator toilet that breaks down the waste and pushes it straight to the main sewer line rather than via a sewer line from the bathroom.

You can DIY your toilet flapper replacement if you’re up for a small plumbing project. Turn off the water to the toilet, open the tank lid, remove the chain from the lever, and unhook the flapper. For a new, adjustable flapper, adjust it to the right setting according to your toilet's gallons per flush rating. Hook the flapper in place and install the chain with 1/2 inch of slack.