Get matched with top epoxy flooring pros in Ansley, NE

There are a few different types of finishes to choose from for the final step of the project. 

Water-based polyurethane sealants emit fewer odors and fumes but dry quickly, which can pose a challenge when trying to get a smooth coat. Oil-based polyurethane sealants let out more odors and fumes into the air (it’s especially important to wear a respirator if you choose this type), but they take longer to dry, which can be more forgiving during the finishing step. 

Some may prefer wood oil to polyurethane because rather than creating a layer, it becomes part of the wood. Wood oil takes longer to dry, and is less resistant to wear and tear; however, it creates a natural-looking result by enhancing the grain of the wood. 

As with anything you buy, be wary of prices that seem too good to be true. Some low-cost flooring products can contain chemicals that release harmful VOCs (volatile organic compounds) in the form of fumes that can be inhaled or dust that can cause skin conditions.

Even good-quality products can be dangerous for DIY-ers who don’t take proper precautions. Always carefully read manufacturer instructions and wear the recommended protective gear when working with paints and other chemicals. You can also hire a local garage flooring pro with the experience and equipment needed to perform the installation safely with no lingering fumes or debris.

The relative cost of adding an epoxy coating to your garage varies compared to other flooring materials and the type of epoxy. For example, epoxy can cost between $3 to $12 per square foot to install, which typically costs more than other garage flooring options, such as concrete sealers, vinyl, and concrete stain. In comparison, vinyl SPC flooring for garages cost between $3.50 to $8 per square foot and concrete sealer costs $50 to $420, depending on the type of sealant.

Door transitions can work with virtually any flooring type; however, different transition strips lend themselves better to specific flooring types. For instance, if you are bridging the gap between a taller floor, like carpet, to a shorter floor, like hardwood, then you will want a transition strip with a slight slope to bridge the height difference. These transition strips are called reducer molding. On the other hand, if you are bridging two floors of the same height, you can use flat transition strips, such as T-strips and seam binders.