Get matched with top pressure washers in Linton, ND

While power washing isn't a requirement before you stain a fence, it can make the job much easier and faster while reducing manual labor requirements. The stain will not work if the wood is full of dirt and dust, so power washing, sometimes called pressure washing, is a fast and effective way to prepare the wood for staining. Remember that you need to stain or repaint relatively soon after the wood has dried so that there isn’t time for dust and dirt to build up again. 

On average, pressure washing a house can take anywhere from 30 minutes to three hours. The time frame to pressure wash or power wash your home, fence, or other property depends on the size of the project and the complexity and accessibility of the areas that need cleaning. Part of the time required to complete the job includes setup and removal of equipment needed. A two-story house with a steep roof may require working from scaffolding or a ladder, likely adding to the time required to finish the project. 

Some hard surfaces, such as concrete and asphalt, tolerate pressure washing well, and it can be a great way to keep them clean. However, you should avoid pressure washing clay or grass as you'll quickly destroy them.

Additionally, pressure washing can remove paint lines from any surface, so you need to be careful, and it may be best to let professionals handle the job.

You can get more pressure out of your pressure washer by adjusting the pressure control knob clockwise to increase pressure (+). You can also check your nozzle for debris and clogs and remove anything you find with needle nose pliers. Switch to a nozzle with a lower-degree spray angle or a turbo nozzle to achieve more pressure at the tip. Check for leaks in the hose and connections, and make sure your water supply is offering enough pressure.