Get matched with top marble restoration pros in Beulah, ND

Extensive chips and cracks may require a full replacement of the countertop. The cost to install a new countertop is around $3,100 on average. But, if the damaged area is relatively small, you may want to consider repairing it yourself or calling in a qualified professional. Depending on the material, some epoxy and sandpaper may do the trick. Or you can consider painting laminate countertops or refinishing butcher block countertops.

Yes, Corian® and other solid surface materials can be cut with standard woodworking tools, such as a circular saw or a jigsaw. However, it is crucial to use the correct type of blade to avoid damaging the material.

For a circular saw, a tungsten carbide-tipped blade is required; a triple chip grind blade is highly recommended. For a jigsaw, you should use a fine-tooth down-cutting blade. Do not use blades designed for cutting wood, as they can cause microfractures that weaken the edges of the countertop. A diamond blade is also unnecessary, as those are designed for harder materials like natural stone, which Corian is not.

After cutting, the edge will be rough. It is essential to sand and smooth the cut edge to prevent microfractures, which can eventually compromise the integrity of the countertop.

Using water when cutting stone drastically reduces the amount of dust that comes off the stone. It’s beneficial to cut down on the amount of dust for respiratory and other safety reasons, such as keeping your vision clear while using an electric tool. Even with protective eyewear, the dust can still cloud your safety glasses. You should always wear protective gear when cutting stone.

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.