Best floor polishers near Belfield, ND

Before starting on a full refinishing project, determine if your floors need to be completely sanded down to the bare wood or if the damage is shallow and mostly cosmetic. Deep scratches and gouges will require you to rough sand using a drum sander or belt sander, but small surface scratches or floors that have only lost their luster don’t need a complete overhaul. Instead, you can skip the rough sanding step and sand-screen the old finish with a buffer, removing only the top layer of polyurethane.

Yes, but with caution. A floor grinder is intended to level and polish concrete, so it is a very powerful tool. To remove paint, the floor grinder should be set to 35 square feet per minute or less to minimize the pressure without the use of pocket weights. You might need to go over the surface two times to get any paint that has sunk into the concrete’s pores.

You can buff out small scratches or indentations from your hardwood floor, but refinishing is your best bet if you have larger areas that need work. Floors in relatively good shape but have lost their luster can be restored with thorough buffing. If your finish has worn off in areas or if you have sun or water damage, you should go with refinishing instead.

You should strip and wax hardwood floors every six months to two years. The actual length of time between stripping and waxing depends on the wear and tear that the floors see. Stripping and waxing floors can help repair hardwood floor damage and give the room a fresh look.