Get matched with top brush chipping pros in Pinehurst, NC

Typically, the best type to trim bushes is when they’re dormant. Winter and late fall, potentially even early spring are the best times to trim your bushes. These seasons allow you better access to the branches, as all leaves are gone and the branches are more brittle, making the trimming process easier. 

The most common alternative is burning the stump first, then dealing with the cinders and ashes. As you can imagine, this option creates fire hazards, especially since roots can burn underground, hidden, for long afterward. That’s why many states and cities have outlawed the use of stump burning entirely. We do not recommend this option as a viable alternative unless you get a permit from the local fire department and practice all safe burning procedures.

Others prefer a more long-term DIY approach of degrading the stump with home mixtures like Epsom salt and vinegar injected directly into it. This may help the stump decay faster, allowing homeowners to dig it out themselves, but it’s still a lengthy process. It usually takes months for a stump to start falling apart with such treatments, and in the meantime, it can be vulnerable to rot, insects, and other problems.

According to the College of Agriculture and Life Sciences, there are over 10,000 kinds of mushrooms, and some are harmful to both humans and animals. However, not all mushrooms are harmful—some feed on thatch and wood, which provides nutrients for grass and plants. 

But unless you’re a mushroom expert (mycologist), it can be hard to tell poisonous mushrooms from non-poisonous. So if you have kids or pets (or both), removing them is the safest route to take.

Depending on the method you choose to remove grass, it may or may not matter whether the grass is wet or dry when you perform the task. A dryer lawn will be easier to negotiate with a sod cutter, especially if you're not planning to reuse the turf. However, using a shovel by hand might be a little easier if the ground is slightly damp but not so much that it sticks to the tool.