Best epoxy flooring pros near Kure Beach, NC

Yes, you can seal an old concrete floor as long as you remove stains and repair damage before sealing. Remove everything from the garage and clear the floor throughout with a concrete cleaner and power washing. Fill in cracks larger than 1/8 of an inch wide and remove all grease and rust stains before sealing. Make sure your concrete is fully dried before applying sealer.

Yes, you can seal old or existing concrete, but proper preparation is crucial. The concrete surface must be clean, dry, and free of any incompatible old sealant. To check if an old sealer is present, drip a few drops of water onto the surface; if the water is absorbed in under five minutes, it's ready to be resealed. If you plan to use the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are using a different type of sealer, the old one must be completely removed. Before applying the new sealer, thoroughly clean the concrete and repair or fill any cracks to ensure a smooth, well-prepared surface.

Yes, you can seal old concrete, but proper preparation is essential. Before sealing, ensure the concrete is clean, dry, and free of any old sealant. To check if resealing is necessary, place a few drops of water on the surface; if they are absorbed in less than five minutes, it's time to reseal. If you are using the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are applying a different type of sealer, the existing one must be removed. Additionally, repair or fill any cracks to create a smooth base before you begin sealing.

No. You cannot use asphalt products on concrete driveways. To seal a concrete driveway, use acrylic, epoxy, polyurethane, silane, siloxane, and silicate sealers or deep penetration sealers made specifically for concrete. Meanwhile, asphalt sealers contain refined coal tar (asphalt emulsion), water, sand, clay, polymers, and additives and are incompatible with concrete’s surface texture and higher density.