Get matched with top concrete resurfacing pros in Kenly, NC

Stamped concrete overlays last about 25 years when properly installed and cared for. Installing an overlay on top of structurally sound concrete helps ensure it reaches its full lifespan. A local stamped concrete pro should finish and seal the concrete upon installation, and you should reseal the overlay every three to five years. Stamped concrete overlays are durable, long-lasting, and a beautiful way to refresh a space.

Whether resurfacing concrete is worth the cost depends on the condition of the underlying slab. Resurfacing can be a good option if the concrete is in decent condition with only minor issues like standard wear and tear, small cracks, chips, or discoloration. In these cases, resurfacing adds a protective layer that can extend the concrete's lifespan without the high cost of a full replacement.

However, if the concrete has significant damage—such as deep cracks, peeling, sinking, or is broken up—resurfacing may not be worth it. The new overlay is only as good as the concrete beneath it, and existing problems like peeling and cracks are likely to show through the new surface. In situations with severe damage, replacing the entire slab is often more cost-effective in the long run and will yield a better result.

To make the best decision, it's recommended to have a licensed concrete specialist inspect the damage and determine if resurfacing is the right choice for your situation.

The best solution to fix a foundation crack in your basement floor depends on the underlying cause. If you just have hairline cracks from settlements that are no longer growing, the best option is to seal them with a crack sealant. If the cracks continue to grow, one edge rises above the other, or there are signs that water is getting in through the crack, a professional repair will be necessary. Depending on the root cause, your professional may employ foundation underpinning or some other type of stabilization, seal the cracks, or install a drainage system.

Concrete resurfacing and concrete overlay are terms often used interchangeably to describe the process of applying a new, thin layer of pre-blended concrete over an existing slab. This process enhances the durability and appearance of the concrete, giving it a fresh look without the high cost of a full replacement. The new layer is typically between 1/4-inch and 1-inch thick, significantly less than the 4 inches required for a new slab, and can be stamped, colored, or textured for a custom finish.

While the terms are often considered the same, their meaning can sometimes vary by contractor. Some may use "overlay" to describe a thicker application that adds structural integrity, while "resurfacing" might refer to a thinner layer intended for cosmetic upgrades. Other common names for this process include concrete restoration, concrete refinishing, and concrete rejuvenation.