Get matched with top sonic cleaning pros in Belville, NC

For the best chemicals to clean a metal roof, stick to gentle detergents such as dish soap, laundry detergent, or car-wash soap mixed in a diluted solution of ¼ cup of soap to 1 gallon of water. These mild cleansers are safe for most roof finishes but are still strong enough to remove remaining dirt particles. Chemicals like bleach or acids can damage your roof, poison landscaping and grass, and pose a hazard to you and your family. If your roof is very dirty or you think it requires chemical cleaning, call a roof cleaning professional.

Chemical herbicides will kill moss permanently. The same goes with bleach water. However, moss can start growing again once a new layer of dirt and debris is caught in your sand in paver joints. Therefore, the problem is not about killing moss permanently, but ensuring effective prevention of moss regrowth.

Walking on the roof to clean gutters is unsafe and not recommended due to significant safety risks. It is especially dangerous on steep or slippery roofs, or if the roof is wet or covered in leaves, which increases the chance of a fall. In addition to personal injury, walking on the roof can damage shingles, potentially leading to water leaks. Instead of walking on the roof, use a sturdy ladder positioned on a stable surface to access the gutters. Be aware that using a ladder also carries risks, as it can be difficult to maintain balance while performing the work. You can also use ground-based cleaning tools. For safety reasons and to prevent damage to your roof, hiring a professional to clean your gutters is the best and safest option.

Moss grows in dark areas of roofs, including in corners and gutters. If left alone, it can grow under roofing and cause permanent damage. Here’s how to remove moss from metal roofs: 

• Soak the moss to soften it

• Scrub it away with a soft-bristled brush, or pick it off with your hands (be sure to wear gloves)

• Use a moss remover that’s compatible with metal roofing, following the manufacturer’s directions

• Remove dead moss and rinse the roof thoroughly

• Prevent future moss growth by trimming branches, cleaning gutters, and attaching zinc strips to moss-prone areas