Get matched with top concrete driveway pros in Aurora, NC

You can whiten concrete for unsealed and unfinished concrete with a solution or either muriatic acid or bleach and water—but never both. However, if your concrete does have a stain, finish, or polish, keep in mind that these hard chemicals could damage the topcoat. Your best bet otherwise is to power wash outdoor concrete slabs or clean indoor ones with a gentle cleaner such as laundry or dish detergent.

When hiring a professional to pressure wash your home, it's crucial to choose a company that is bonded, licensed, and insured. This protects you from liability if any accidents or property damage occur during the service; otherwise, the cost could fall on you. Before making a decision, vet at least three different contractors. Conduct thorough research by reading customer reviews, looking at examples of their previous work, and verifying the company's license. Before signing a contract, ensure you receive a written estimate that details all project costs. It's also wise to ask potential contractors a series of questions to gauge their professionalism and experience, such as:

• How many years of experience do you have?

• What are your credentials?

• What cleaning methods do you use?

• Do you have a workmanship warranty and insurance?

• What is your availability?

• What is your policy if you damage my property?

• How long will the job take to complete?

• How much do you charge?

• What is your cancellation policy?

• Do you offer a customer satisfaction guarantee or any additional services?

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.

Excavators work in tandem with dump trucks to haul away excess dirt and soil. The excavator will dig into the ground and move the excess dirt into a pile. Using a backhoe, the specialist can fill a truck with excavated soil from that pile. They will then drive the truck to a different location where they can dump the material.