Top-rated gas leak repair technicians.

Get matched with top gas leak repair technicians in Sanders County, MT

Enter your ZIP and get matched with up to 5 pros

Need a pro for your gas leak repair project in Sanders County, MT?

Select your specific project to find the pro for you.

Find Gas leak repair technicians in Sanders County

LEAK DETECTION WITHOUT DESTRUCTION, REPAIR SWIMMING POOL, SLAB, SEWER LEAKS, SPRINKLER SYSTEMS, SWIMMING POOL CRACK INJECTION, CONCEALED PLUMBING SYSTEMS.

Gas Leak Repair questions, answered by experts

Yes, it’s possible to convert an oil furnace to gas. However, you may have to replace the furnace completely instead of simply converting it. If the original oil furnace has had any type of damage or is older (typically considered over 15 years old), then you will likely need a full replacement versus a conversion.

Modern gas fireplaces are relatively efficient and don't burn excessive amounts of gas, especially compared to older models. A gas fireplace might use between 10,000 to 40,000 BTUs per hour; the total amount of gas used depends on the fireplace's size, heat output, and how often it's in use. To help keep your running costs down, consider using a thermostat and turning off the fireplace when not needed to minimize gas consumption

Shut-off valves, like any other piece of metal hardware, can corrode, age, get worn down, and eventually break or rust into place. Occasionally spray your shut-off valve with WD-40 to stall it from rusting. If it really gets stuck, a wrench and WD-40 will usually do the trick, but you will need to call a plumber if it’s completely unmovable.

While some building codes allow galvanized pipe for natural gas, it shouldn’t be used for propane. Propane can cause the pipe to wear down, leading to dangerous leaks. Instead of galvanized piping for propane, you should consider coated copper, black iron, or corrugated stainless steel tubing (CSST). For underground propane line installation, you can use polyethylene (PE).

The cost to repair a gas leak is $120 to $250 on average, but it could be as costly as $5,000, depending on the leak location and severity. 

For example, if you have drywall covering the source of the leak, you'll need to hire a contractor to replace the removed drywall. In addition, if the leak is underground, you'll need a contractor to excavate the ground to reach the gas line. 

The Sanders County, MT homeowners’ guide to gas leak repairs

From average costs to expert advice, get all the answers you need to get your job done.