Get matched with top deck staining pros in Ravalli County, MT

Yes, staining or sealing a cedar deck or fence is highly recommended to extend its lifespan, typically by five to 10 years. While cedar is naturally resistant to mold and mildew, it can still fall victim to moisture, sun exposure, and rot over time. Applying a treatment creates a protective shield that helps prevent splintering, fading, and decay, preserving the wood's strength and appearance. A combination stain and sealer often provides the best protection, as it soaks into the wood grain rather than just sitting on top. This offers superior defense against UV damage and rot and lasts longer than a sealer alone. To maintain the wood's natural look, consider using a near-translucent stain. You should plan to reapply the stain or sealer every two to three years.

Waterproof paint creates a barrier to hold back moisture, but it doesn’t eliminate the source of the water. If you hire a basement waterproofing contractor, many will tell you that waterproof paint is only a temporary solution. On average, you can expect it to last from six months to two years in a wet basement before deteriorating.

You can paint over old paint on a concrete porch. For the best results, you should first clean the surface and remove as much paint as you can. A power washer is helpful here, but you’ll also want to scrape as much of the old paint away as possible. Then you should prime the porch before repainting it.

Whether to brush or roll stain on wood depends on the project and your preference. Brushing is ideal for smaller, intricate areas and offers more control over the application, ensuring thorough coverage and penetration into the wood's grain. 

Conversely, rolling is efficient for more extensive, flat surfaces and can save time. However, it is not always the best fit for textured or uneven wood. Some projects may benefit from combining both methods, using a brush for detail work and a roller for broader areas. Ultimately, the choice between brushing and rolling depends on the specific requirements of your staining project.