Top-rated masons.

Get matched with top masons in Marion, MT

Enter your zip and get matched with up to 5 pros

Need a pro for your masonry work project in Marion, MT?

Select your specific project to find the pro for you.

Find Masons in Marion

Avatar for Montana Excavating Services LLC
Montana Excavating Services LLC
5.0(
4
)

Serving Marion, MT and surrounding areas

In business since 2002

Free estimates

"It went great! I had a huge problem with water standing to close to my home they fixed my issue, and also found a path for the water to drain out. I’d highly recommend them with any dirt work problems."
Mr. Scott shows just how crucial it is to be precise in your work.
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by100%of homeowners
Avatar for Solid Concrete Works
Solid Concrete Works
5.0(
1
)

Serving Marion, MT and surrounding areas

"We were looking for someone to pour a large patio slab and it's always a roll of the dice when looking for reliable and competent craftsman today. We wanted someone who who was honest (of course), who knew what to do, and how to do it, and communicated reliably. Logan was all of that AND polite, easy to deal with, punctual (and texted if he was going to be delayed), just a good all around human being. We will be calling him again soon to have another job done by him. Better book him soon before the word gets out and the wait times get long."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+7

Recommended by100%of homeowners
Showing 1-10 of 24
Masonry questions, answered by experts

No, you don’t need to soak the brick before cutting it by hand. In fact, cutting a wet brick can make it harder to see your score lines and may cause the chisel to slip. Soaking is sometimes used with power tools to reduce dust, but for hand-cutting, it’s best to work with dry bricks for better control and visibility.

Discoloration ondifferent types of brick can range from harmless to red flag. For example, efflorescence that is caused by a buildup of water-soluble white salt is considered harmless. However, green or greenish-yellow stains are caused by salts that are harmful to brick. Staining can also be caused by rust, corrosion, lime run, soot, algae, or moss.

Fireclay is a type of clay but it is a type of clay that, because of its chemical composition, can be fired at a much higher temperature than other clays. This results in a denser and more heat-resistant final material. Because of the high percentage of a mineral called kaolin, fireclay sinks are smoother and more durable than other clay types.

Cobblestone is not a type of rock but a term for a mosaic or rock laid down as a surface. It used to be made from the closest available stone but now can be made from nearly any hard rock, as machining has made shaping the stone much easier and cheaper.

It is possible, albeit a lot slower, to break up a rock using water. You would do this by freezing and thawing the water. You could create some initial holes or cracks in the rock, then pour water into the cracks or holes and allow them to freeze (so it's best to do this in winter or in colder climates). Since water expands when it freezes, this puts pressure on the inside of the rock and causes it to crack. You could continue to pour more water in and let it freeze to continue to break up the rock.

The Marion, MT homeowners’ guide to masonry services

From average costs to expert advice, get all the answers you need to get your job done.

What do you need done? We’ll find top pros.
  • 🌱 "Mow a small front yard"
  • 🛠 "Fix a leaking pipe under the sink"
  • 🏠 "Repair shingles on an asphalt roof"