Get matched with top water heater pros in Malta, MT

No. Expansion tanks must be installed on the supply side (where heated water flows out) of the boiler. There’s also a list of other requirements for most boilers, including being above the pressure relief valves, being on the inner side of any circulator, and more. Your installation manual should have more information on expansion tank installation requirements and what sort of tank the system is made for.

The average cost to install a new water heater is approximately $1,300, with a typical price range between $880 and $1,800. The final cost depends on several factors, including the type and size of the unit, its location and accessibility, and the amount of labor required. For example, installing a unit in a tight space like a crawl space can increase labor costs. The type of water heater significantly impacts the price: while a conventional gas heater might cost less than $1,000, tankless models can cost around $2,600 to install (and up to $3,500), and solar heaters can cost upwards of $3,700. Other factors that can affect the total price include the fuel type, vent system requirements, permits, and whether any additional plumbing work or repairs from previous water heater damage are needed.

A tankless water heater can last up to 20 years, which is nearly double the lifespan of a conventional tank heater. However, their longevity is highly dependent on several factors. With proper installation and regular maintenance, such as descaling to prevent mineral buildup from hard water, you can expect a lifespan of 15 to 20 years. Without proper care, a tankless unit may begin to fail in as little as 12 years. Other factors that affect its lifespan include household usage and the quality of the local water supply. While they have a higher upfront cost, their energy savings, smaller size, and longer life make them a worthwhile investment for many homeowners.

The standard copper wire gauge to use with any 30-amp circuit is a 10-gauge wire. The National Electric Code specifies a 10-gauge wire with appliances like water heaters running on 30 amps. If you try to use a smaller gauge wire, such as a 12 gauge, with a 30-amp breaker, you run the risk of the wire overheating and melting or causing a fire. Because of the safety hazards, the gauge of the wire is not an area to try to cut costs when connecting a 30-amp breaker to a water heater.