Get matched with top concrete driveway pros in Lolo, MT

If your epoxy application ended up a bit messy and left spills behind, there are several ways to clean epoxy off of a concrete floor. You can use a power washer with at least 3,000 PSI. However, it may be easier to use a scraping tool or an acidic cleaner, like vinegar, to remove unwanted epoxy. 

If the entire floor has epoxy and you want to remove just excess epoxy stains, these methods could still strip parts of the epoxy floor. Move carefully and in small areas to minimize damage, or call a pro for an expert finish.

The average cost to pressure wash a house is around $310, with typical prices ranging from $200 to $420. However, the total cost can vary widely, from $200 to $750. Power washing, which uses heated water, may cost between $250 and $400 per project, with an average of $200 to $300 for a 2,000-square-foot home.

Key factors that influence the final price include:

• The size and height of the house (a multi-level home costs more than a single-story one).

• The complexity of the job and accessibility of certain areas.

• Geographic location.

• Equipment and hourly labor costs.

Hiring a professional is often recommended as they bring their own equipment and cleaning solutions. Experienced professionals know how to complete the job effectively without causing damage to your siding, gutters, or landscaping, which can be a risk with high-powered water jets.

The best cleaning solution for stamped concrete is a combination of water and mild soap. Dish soap and laundry detergent are good options. For more stubborn stains, you can use an alkaline cleaner that removes oil and grease. In either case, you’ll want to steer clear of abrasive cleaners and harsh chemicals which can damage the concrete.

Yes, you can pressure wash epoxy floors, but you must take precautions to avoid damaging the surface. While most epoxy floors can be cleaned with a mop, you might choose to pressure wash if the floor is stained, has ground-in dirt, or is covered with mold or mildew. To do so safely, first soak any stains or dirty areas with a gentle cleanser. Use a lower pressure setting with a gentle nozzle, such as a green, white, or black tip, or a 45-degree angled tip. Keep the spray nozzle at least 18 inches away from the floor to protect the surface. Using a surface cleaner attachment or a rotary scrubber can also help prevent overspray. Be cautious if using a power washer that heats the water, as the combination of heat and pressure may be too powerful and could damage the epoxy coating.