Get matched with top carpenters in Ledger, MT

"Found Sentri on Angi. Jeanette and Violet were very pleasant and efficient in getting a contractor to me in the time frame needed. The contractor was excellent and the roof looks great! I would definitely work with them again if I had additional projects."

"Hello, My name is Phil Carr-Jones, I am reviewing my experience of working with and building my own kitchen, using cabinets and doors from Arkansas Wood Door. While I am an Episcopal Priest, it turns out I get to do a lot of things they don't teach you in seminary. Over the years, I have had to get fairly skilled in all the trades, including, no surprise, carpentry. But I am by no means an expert. For instance, I employed a retired carpenter to help out with the crown molding and other trim. Apart from that though, this is all my and my wife's work. So let me state up front, Arkansas Wood Doors is the go to place for the DIY’er who is thinking of remodeling their own kitchen. Here's why: I searched the web for months, literally doing comparisons and research on flat pack rta cabinets. I went to the big box store for a design and pricing in their three lines of cabinets, and I went in for a consult with a small custom shop in my area. Here's what I found. 99 outof 100 rta cabinet companies have their product made in china which means the standards for formaldehyde are going to be as fishy as they smell, plus you can only get cabinets in fixed sizes so if you looking to eeck out every last inch of space you're going to lose a lot and you'll be using a lot of filler strips wasting what could have been useful storage. If you want to go custom, then you only have less than a handful of online options, companies that will make to order in any dimension. For instance, I only wanted an 8 inches deep spice cabinet to allow for greater working room over the counter. My wife and I are pretty serious about cooking from pastries to mains and sides. We want a very serious kitchen. Plus, I'll tall so I needed the room. In any case, if you want something custom your choices online are limited. The big box stores don't really do custom and are just as limited in their options as are the online rta places. Most online rtas offer far cheaply made boxes with construction methods less sturdy. I have found that if I buy cheap, I shouldnt expect my kitchen to hold up past a few years. The finish will fade. The drawers will warp. The joints will open up. The big box stores basically offer the same thing, too. When I go to a big box store to buy something, I do it knowing I probably willl get a year out of it, whether that’s a lawn chair of a power tool. I mean when was the last time you regretting spending too much money on a better grade of power tool? So if you want quality, a better and safer grade building material and much wider choices in sizing then your basically down to three or four options. I went with Arkansas Wood Door and am completely pleased and impressed by the experience. Now I could have spent twice what I did and gone to a small custom shop and gotten the same thing, but I am in to saving money and frankly I enjoy the challenge. AWD worked with me directly. Working up the order and getting the plan for each box just right. If you have never designed and built a kitchen before, there are plenty of tips and guidance on the web and I recommend you heartily research all of the aspects and complications involved. I hit a couple of unexpected bumps. But more about that below. So do your research. For instance you can save a lot of money by building the plinths yourself and only order squared off boxes without the toe kick. By making the platform on which you place the lower cabinets first, you can get that plumb and level, so throwing up the boxes is a breeze. And again, the cabinets are also less expense, a complete all around win. AWD uses an easy system for matching up box parts so assembly was easy. No special tools required. Given the many parts and I used a mix of frameless and face framed cabinets, there was a moment or two when in amongst all the materials I got nervous about having everything I needed, but low and behold, all was right there in the end. I also recommend the concept from French cooking "mis en place" that is have all your ingredients in place and all your tools where you need them before starting out. Also, it was a lot easier to work with my wife than doing it alone, but I did a few by myself and so if that is your only option than you should have no problem. I've assembled a lot of cheaper Swedish flat packed furniture in my day, and the quality and sturdiness of AWD leaves no doubt about how long these will last. Just rock solid. Great thing about AWD is the cost to quality ratio. Cant beat it. Which also means if you make a mistake the replacement is so reasonable it becomes not big deal. I mis-measured one box and so I needed to order the right size. Worked out fine, but that was because AWD had an incredibly fast turn around. The other few reliable companies are several weeks to months. And these other places are crazy expensive. And in truth, the other companies are a complete rip off on trim and accessories. AWD pricing was so amenable that my mistakes cost me so little in comparison with what I was saving. So there's a built in confidence for the first timer. Also AWD made one mistake on the placement of a hinge in two doors. They immediately and without question remade them and sent them out in under ten days. You just can't get that service anywhere in the custom cabinet world. It was so affordable I upgraded on one side to black walnut. Trying doing that at the other quality shops. The quality of the roll out drawers and top drawer boxes is superb and the hinges and under-mount sliders are top grade excellent. The hardware was the easiest part frankly. Their system, for lining up the hardware is just so easy. Drill driver is all you need as the placement is already leveled for you. SO: high end quality custom built cabinets, superior custom support, fastest turnaround in the marketplace, most affordable pricing out there, excellent hardware, and oh yeah, I almost forget, color choices. They offer complete line of lacquer - just pick a SW color and they'll match it. SO completely and truly custom for a fraction of cost without sacrificing any quality. The Rev. Philip Carr-Jones"

"It is a waste of money. The great majority of people are not going to find any value out of the service. If you need design consultation, you need a full service consultation. If you already have knowledge and experience, and you just need to get a few ideas, then you don't need to pay for that. You can just get a magazine or a book since you already have the knowledge of basic designs in your head or a little bit of experience. To have someone call you and give you information over the phone, you are not getting the personal service that you need. You may as well take the money $49 and apply it to something else like getting someone else to come out and give you the service that you need. Because, you are not getting much, you are not getting anything at all. They are going to have you do the work. After talking to them and I was talking to other home designers, I found out that that was a waste of time and waste of money. I gave them a C because they didn't fail at what they do but they don't offer any value for what they do. There's not much value to it. The cost was fair. They didn't do a terrible job and the cost isn't terrible, it was only $49. It just has a very low value. For responsiveness I gave them a B because they will answer your phone and answer your emails."

"Preston of G-1 Plumbing performed the services and addressed the toilet & drain problem. He was unable to stop leak(made it worse) & submitted his recs to Choice Home for review. I was unable to understand Choice Home's response regarding the faucet leak. Their review stated faucet needed to be replaced BUT it was under "builder's warranty." I built this home in 2005. There is no "builder's warranty" now. I cancelled the proposed work order & paid out-of-pocket. A Friend, who was familiar with my builder and knows faucet components, came to my home, adjusted/cleaned the faucet cartridge and stopped the leak. The CHW tech, Preston, is conscientiuos, however, IMHO lacked the knowledge & experience to stop my leak. Home Warranty Companies, at least in my area, hire owner/operators who need the work to build their business and are NOT the most experienced/knowledgeable & are willing to work for less money. In my experience, Home Warranty Companies want the CHEAPEST resolution, not the BEST. I would recommend G-1 Plumbing for most plumbing issues."

"not to good :( I felt I did most of the work by providing all the details floor plans and colors.  What I got back was only two floor plans and some websites to purchase living room deco and some paint samples. Not enough for the money I paid. It also took a month or so before I received these things too.
"

"This was the service provided by AHS's contractor Myers Comfort Specialist.  They would only provide a 2hr window with a 30 min notice of when they would be there. They agreed to come out between 3pm - 5pm that day; later around 4:30 I call to see when they would be out and discovered the tech had call the wrong number and they couldn't come out until the next day. The tech came out and diagnosed the problem, but he need a part. Later that day, when I called to inquire about a time frame I was told by a supervisor that the technicians do not turn in paperwork until the next morning and then the part would be ordered. I received a call the next day that the part was available, but they could only come out between 1pm and 5pm with a 30 min notice. I ask to schedule the first appointment for the next day and was told they would set up a time to be out between 8am - 10 am with a 30 min notice. At 10am the next morning, no call, no show. I called MCS and was told the technician was delayed at the warehouse picking up the part and would call shortly. (I'm not sure why the part was not picked up the day before when they said the could come out?) Also called AHS and explained the situation and asked to have the $75 service fee waved, which they agreed to do. The tech arrived about 11am installed the part and was finished about noon. Between the initial call and the repair visit I end up missing almost a whole day of work.
"

We pride our company on reliability, great communication, integrity, and quality work. We are experts in our trade and will do our best to keep you as educated as we can on your particular task or project. We look forward to earning your business! \nBook with us online or feel free to give us a call today!\n

Our mission at Hampton Enterprise LLC is to provide clients with superior customer service, quality work and speedy service in all aspects of their home improvement needs. Licensed, insured and trusted since 1989; come discover the Hampton difference today!\n\nWe specialize in the installation and repair of Windows, Doors, Flooring, Sinks, Bathtubs, Showers, Sprinkler Systems and much more. We also offer Interior and Exterior Home Painting, Custom Welding Fabrication and Carpentry.Localy in your area just call and i will call back with a local number thank you . from James Hampton\n\nAL.Dothan 334-648-3817,\nAL Birmingham 334-648-3817,\nAL Huntsville 334-648-3817,\nAL Mobile 334-648-3817,\nAL Tuscaloosa 334-648-3817,\nAL Montgomery 334-578-4761,\nAR Little Rock 334-648-3817,\nAZ Phoenix 334-648-3817,\nCA LosAngeles/Sacramento 334-648-3817,\nCO Denver/Colorado Springs 334-648-3817,\nCT Hartford 334-648-3817,\nDE Dover 334-648-3817,\nFL Tallahassee 334-648-3817,\nFL Cape Canaveral/ Cocoa 334-648-3817,\nFL. Destin 334-648-3817,\nFL Gainsville 334-648-3817\nFl Jacksonville 334-648-3817,\nFL Orlando 334-648-3817,\nFL Panama City 334-648-3817,\nFL Tampa 334-648-3817,\nFL Miami 334-648-3817,\nGA Atlanta 334-648-3817,\nGA Albany 334-648-3817,\nGA Augusta 334-648-3817,\nGA Columbus 334-648-3817,\nGA Macon 334-648-3817,\nGA Valdosta 334-648-3817,\nIA Des Moines 334-648-3817,\nID Boise 334-648-3817,\nIL Chicago/Springfield 334-648-3817,\nIN Indianapolis 334-648-3817,\nKS Levenworth/Topeka 334-648-3817,\nKY Frankfort 334-648-3817,\nLA New orleans/Baton Rouge 334-648-3817,\nMA Boston 334-648-3817,\nMD Annapolis 334-648-3817,\nME Augusta 334-648-3817,\nMI Detroit/Lansing 334-648-3817,\nMN Saint Paul 334-648-3817,\nMO kansas City/Jefferson City 334-648-3817,\nMS Jackson 334-648-3817,\nMS Biloxi 334-648-3817,\nMS Gulf Port 334-648-3817,\nMT helena 334-648-3817,\nNC Raleigh 334-648-3817,\nND Bismark 334-648-3817,\nNE Lincoln 334-648-3817, \nNJ Trenton 334-648-3817,\nNM Santa Fe 334-648-3817,\nNV Carson City 334-648-3817,\nNV Las Vegas 334-648-3817\nNY Albany 334-648-3817,\nOH Columbus 334-648-3817,\nOK Oklahoma Ciy 334-648-3817,\nOR Salem 334-648-3817,\nPA harrisburg 334-648-3817,\nRI Providence 334-648-3817,\nSC Columbia 334-648-3817,\nSD Pierre 334-648-3817,\nTN nashville 334-648-3817,\nTX Austin 334-648-3817,\nUT Salt Lake City 334-648-3817,\nVA Richmond 334-648-3817,\nVT montpelier 334-648-3817,\nWI Madison 334-648-3817,\nWV Charleston 334-648-3817,\nWY Cheyenne 334-648-3817

Since 2008, Lamar Metalworks, LLC, has enjoyed creating hand crafted products that meet and exceed the expectations of our clients. Since day one we have established interactive relationships with engineers, architects and designers to utilize the structural capabilities of steel. Our approach has allowed our clients to understand and value natural resources as essential contributors to modern, sustainable architecture. Call us today to discuss your project.

Timeless Construction & Design is a locally owned and operated company that values honesty and integrity in all aspects of our business. Our dedicated team of professionals have over 20 years of hands on experience, to provide innovative ideas and suggestions tailored to your projects. Our services are customized to your individual needs, paying close attention to the details of each project that we are involved with. Please feel free to contact us today!\n