Get matched with top toilet pros in Glasgow, MT

Yes, you can install a basement bathroom without breaking concrete by using an upflush toilet system, which includes a macerator pump. These systems sit on top of the concrete floor, so you don't have to drill into it to install plumbing. The macerator pump breaks up waste until it is soft enough to pass through a discharge pipe to the main sewage line. This method saves you time and money by bypassing the need to break concrete to connect drain pipes.

Snaking a toilet is similar to clearing sinks and bathtubs, but there are unique circumstances where you’d have to drain, disassemble, and remove the toilet to fix the clog. For stubborn clogs in the toilet trap, a toilet auger—designed with a shorter cable and a protective plastic encasing—can navigate the tight bends and clear the clog without risking damage to the porcelain. 

If you don’t replace a toilet flapper, your toilet tank will continue to empty and fill repeatedly, wasting water and running up your utility bills. Checking the flapper is a good first guess when dealing with a constantly running toilet. However, if these problems continue after replacing the flapper, you may need to hire a plumber to check and fix any bigger problems. 

Yes, a toilet, sink, and shower can share the same vent. This is a common plumbing practice that can simplify installation and save space. When sharing a vent, it's important that the toilet is located downstream from all other fixtures. You will also need to ensure the vent pipe is large enough to handle the demands of all connected fixtures without compromising its effectiveness. Because requirements can vary, you should always check your local building and plumbing codes. Consulting a qualified plumber is recommended to ensure the vent is properly sized, installed, and adheres to all local regulations.