Get matched with top pool and spa technicians in Wade, MS

Hot tub repairs cost between $200 and $500 on average. You can minimize those costs by maintaining your hot tub and keeping necessary supplies on hand. An elevated shelf in the garage is a great place to store your water care chemicals so that kids and pets will stay safe and you’ll always have them around. 

Your hot tub should be drained of existing water, cleaned, and refilled every three to four months at a minimum. Follow your tub manufacturer’s recommendations for cleaning, and rinse thoroughly when finished to eliminate any residue from the cleaning products. This is also a good time to inspect your tub’s cover in good lighting for any leaks, tears, or other damage that might cause problems. 

Using your hot tub manufacturer’s suggested cleaners and methods, keep your hot tub filters clean to avoid a loss of water heat. This will help extend the filter’s useful life and efficiency. If the filter is more than two to three years old, replace it with a new one and buy a second filter to keep around as a spare.

If you don’t clean your hot tub filters, they’ll build up dirt and grime, preventing them from filtering out contaminants like dirt and bacteria. The dirty water will then circulate through the filter and back into the hot tub, leading to dirty water, a damaged pump and jets, and low heat. This can lead to higher hot tub costs because you may have to pay for repairs.

Where you drain a hot tub largely depends on local regulations, but you must not drain chemically treated water where it can damage the environment. Direct the water toward a sanitary sewer drain that will take it to a treatment facility. If your lawn has a dedicated drainage area that’s free from plants and foundations, you can likely drain it there. Avoid storm drains, as the hot tub water will enter waterways and could hurt aquatic life. Likewise, do not pour it out directly on any public land or where it can get into your neighbors’ property. 

To refill a hot tub after winter, start by opening up the tub and giving it a quick cleaning. If you use antifreeze, drain out the water then grab a hose and thoroughly clean the tub shell out, spraying water into each jet of the tub. 

Reconnect the hot tub and turn the power back on. When it’s time to fill the tub again, insert the hose into the filter well (if available). Avoid trapping too much air in the water lines, which can cause the pump to lock up when it starts again. Add the necessary chemicals and start the heating process. It will take some time—most of a full day—for the water to heat up again.