Get matched with top pool and spa technicians in Florence, MS

A hot tub cover's lifespan is typically between three and seven years, with an average of five to seven years for a well-maintained one. The quality of the cover is a major factor; lower-quality polyester or vinyl soft covers can tear easily with regular use.

To extend the life of your cover, proper maintenance is key. This includes:

• Keeping the cover clean, dry, and out of the sun. Use a soft cloth and mild dish soap for cleaning.

• Applying a vinyl protectant spray.

• Cleaning the underside with a chlorine spray.

• Using a cover lift to prevent damage from rough handling.

• Protecting it from harsh weather.

• Keeping children and pets off the cover.

Investing in a high-quality cover and checking for a warranty at the time of purchase can also contribute to its longevity.

Hot tub repairs cost between $200 and $500 on average. You can minimize those costs by maintaining your hot tub and keeping necessary supplies on hand. An elevated shelf in the garage is a great place to store your water care chemicals so that kids and pets will stay safe and you’ll always have them around. 

Your hot tub should be drained of existing water, cleaned, and refilled every three to four months at a minimum. Follow your tub manufacturer’s recommendations for cleaning, and rinse thoroughly when finished to eliminate any residue from the cleaning products. This is also a good time to inspect your tub’s cover in good lighting for any leaks, tears, or other damage that might cause problems. 

Using your hot tub manufacturer’s suggested cleaners and methods, keep your hot tub filters clean to avoid a loss of water heat. This will help extend the filter’s useful life and efficiency. If the filter is more than two to three years old, replace it with a new one and buy a second filter to keep around as a spare.

You can and should use a hose to fill a hot tub. There shouldn’t be anything special about the hose other than it shouldn’t be damaged. Kinks or leaks could slow down the filling process. Attach the hose to the nearest spigot and get the water flowing.

To refill a hot tub after winter, start by opening up the tub and giving it a quick cleaning. If you use antifreeze, drain out the water then grab a hose and thoroughly clean the tub shell out, spraying water into each jet of the tub. 

Reconnect the hot tub and turn the power back on. When it’s time to fill the tub again, insert the hose into the filter well (if available). Avoid trapping too much air in the water lines, which can cause the pump to lock up when it starts again. Add the necessary chemicals and start the heating process. It will take some time—most of a full day—for the water to heat up again.