Get matched with top pressure washers in Smithville, MS

One of the best ways to save money on deck cleaning services might seem counter-intuitive: pay for cleaning annually rather than waiting until it’s necessary. Routine deck maintenance can help you avoid stains and mold growth, both of which can detract from the appearance of your deck and limit its lifespan. Annual cleaning and resealing will keep your deck looking new for longer, adding utility to your yard and improving the overall appeal of your home and its value. You can also save money by coupling deck power washing with other outdoor cleaning services, like fences, patios, and walkways.

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.

Yes, technically, you can pressure wash the paint off of brick. However, you run a much greater risk of damaging the brick and causing serious problems. If you go this route, you’ll still need to carefully choose and apply a chemical paint stripper before washing, following all instructions on the product packaging. Set your power washer to a low pressure to avoid damage.

The difference between pressure washing and power washing is the temperature of the water. With pressure washing, cool water from an outdoor spigot supplies water to the pressure washing machine. With a power washer, the cool water is heated inside the machine, which has a heating coil. The power washer sends out heated, pressurized water for a deeper clean.