Top-rated boiler repair pros.

Get matched with top boiler repair pros in Sharon, MS

Enter your zip and get matched with up to 5 pros

TRUSTED BY SHARON, MS HOMEOWNERS

  • Average homeowner rating star icon4.8
    Average homeowner rating
  • Verified reviews icon88
    Verified boiler repairs reviews

Find Boiler repair pros in Sharon

Drain Go Plumbing
4.1(
89
)
Boiler or Radiator Heating System - Install or ReplaceBoiler or Radiator Heating System - Install or Replace - For BusinessBoiler or Radiator Heating System - Repair or Service+13 more

Serving Sharon, MS and surrounding areas

In business since 1996

Free estimates

Credit card accepted

"My hot water tank stopped working on a Friday night and I was expecting guests. I called them and they came out on a Saturday morning to install a new hot water tank. Josh and Dusten came to do the work and I was very pleased with them. They originally came Friday night and determined it couldn't be repaired. When they came back Saturday, they had the correct tank and everything they needed to replace it. I have used them before for air conditioning service and was pleased with their service then, too."
Recommended by77%of homeowners
Showing 1-10 of 26
Boiler Repair questions, answered by experts

Addressing banging, clanging, and hissing radiators involves several steps. Start by bleeding the radiator to release trapped air, a common source of noise. Next, ensure all valves, brackets, and pipes are securely tightened to prevent the components from rattling. You can also consider installing radiator insulation to dampen heat expansion sounds. If you perform all of these fixes and the noise persists, explore the use of radiator additives that can mitigate water-related noises. If all else fails, you should consult an HVAC professional.

It can be difficult to determine the cause of a coolant leak unless you have the unit inspected by a certified professional. Most coolant leaks are caused by wear and tear on seals and joints. This typically happens five years after a unit is installed. Additionally, faulty or worn compressors, evaporator coils, and condenser coils can also cause leaks.

The average cost for HVAC repairs is approximately $350. However, prices can range from as low as $100 to as high as $3,000 or more, depending on the type of repair and the extent of the damage. For example, a relatively inexpensive capacitor replacement may cost $100 to $500, while a major compressor repair can range from $750 to $2,000. Other common repairs and their typical costs include:

  • Blower motor repair: $200–$500

  • Circuit board repairs: $100–$600

  • Evaporator or condenser coil repair: $400–$1,500

  • Heat exchanger repair: $100–$200

  • Thermostat repair: $175

Some of the signs of HVAC issues include rising energy bills, rooms not cooling or heating properly, loud noises when in operation, and signs of condensation. To illustrate, if you’re wondering how to stop condensation on air vents, you’ll need to have your HVAC inspected. 

In general, it’s a good idea to bleed air from your heaters at the start of every cold season, before you move your boiler system back into active mode. Early fall is a common time for this task. However, some heating systems don’t need much manual bleeding because of automatic bleed vents and other components.

The Sharon, MS homeowners’ guide to boiler repairs

From average costs to expert advice, get all the answers you need to get your job done.