Get matched with top roofers in Pelahatchie, MS

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

A few disadvantages of installing solar panels on your roof include the high up-front costs and the potential for increased property taxes. Installing solar panels can increase the home’s value, which in turn can mean higher taxes. Depending on your area, you should check with your local tax offices for more information. Another potential pitfall is roof leaks from a poor installation, but this shouldn’t be an issue if you hire a reputable company.

The type of roof and roofing materials that are best for your mobile home depends primarily on its shape and slope. Rubber materials, such as EPDM and TPO, are best for flat, low-sloped, or bowed mobile home roofs. Asphalt shingles or metal roofing are best for mobile homes with sloped rooflines.

No, you can’t use your home’s square footage. You have to calculate your roof’s square footage, and then you may have to convert your square footage measurement to correspond with how the roofing material is measured. For instance, some roofing is sold in “squares,” which equals the total square footage of the roof divided by 100. Shingles are sold in bundles that may not correspond to the number of squares you need. Metal roofing is sold as sheets, so determine the amount of square feet each panel will cover and then divide the total square footage by the coverage area.